MUHLER WD-11ED Water Dispenser Instruction Manual

: June 12, 2024
: MUHLER

Table of Contents

IMPORTANT SAFETY PRECAUSIONS
TECHNICAL CHARACTERISTICS
FIRST OPERATION
HYGIENIC MAINTENANCE
WHAT TYPE OF WATER YOU CAN USE
ADDITIONAL INSTRUCTIONS FOR USE
STORAGE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**WATER DISPENSER
Instruction Manual

Model: WD-11ED
570 W, 220-240 V~/ 50-60 Hz**

Please read the instructions manual before using the appliance for the first time and save it for future reference

IMPORTANT SAFETY PRECAUSIONS

Check the mains if the voltage corresponds to the voltage shown on the rating label of the appliance.
The socket outlet must be properly grounded.
Do not turn on, if the cable, plug or the unit are damaged. The damage must be repaired by an authorized service or a qualified person to avoid electrical shock.
In case of damage of the appliances pleasecontact an authorized service.
Do not touch the appliance with wet hands.
For protection against of electric shock do notimmerse the cable, plug or the appliance in water or other liquid.
If you will not use the appliance for a long time or clean it, please unplug the power cord. Do not pull the cable to avoid damage on it.
Do not bend the power cord, or pull it through sharp edges. Do not place it on hot surfaces or fire. Place it like that it doesn’t block the movement of the people and they don’t step on it.
Do not unplug while the appliance is running.
Do not use the appliance in rooms where are located or stored fuels, explosive and poisonous chemicals, or when using flammable glues, sprays, or solvents.
Put and use the unit only on a flat surface.
Do not put objects on the unit.
Do not knock or shake the appliance while it is working, this may stop its working.
The appliance is working properly if the temperature of the environment is between 6 and 30°C.
This appliance is not intended to be used bypersons (including children) with reduced physical, sensory, or mental capabilities, or lake of experience and knowledge, unless they have been supervised or instructed concerning use of the appliance by a
person, responsible for their safety. Cleaning and maintenance must not be done by children.
Children must be supervised not to play with the appliance.“Keten” Ltd. is not liable for damages caused by non-compliance with these instructions, improper use, or manipulation.

COMMON TYPE

Top Cover
Power indicator
Heating indicator
Cooling indicator
Cold water taps
Hot water taps
Drip box

TECHNICAL CHARACTERISTICS

Model	WD-11ED
Cooling power	70 W
Cooling capacity	0.8 L/H≤10°C
Heating power	500 W
Heating capacity	5 L/H≤95°C
Voltage	220-240V~/ 50-60Hz
Current	0,55A
Climate class	ST
Class of protection against electric shock	Class I

FIRST OPERATION

Bring the dispenser in an upright position to the desired location.
The dispenser should be placed in a central and accessible place where the environment does not contain any risk factors for contamination of the water.
The dispenser should not be placed in open spaces, in dusty, humid, or unventilated areas or near toilet facilities.
CAUTION!
Never use the taps to lift the dispenser.
Remove the carton box from the dispenser.
An overview of the device to make sure that:
• There are no signs of physical damage
• All attachments are available
• Taps are solid hold and in an upright position
• All wiring and electrical connections are placed on the back of the unit
• Switch on the hot water in the “OFF” position
• Unit is clean and dust-free
CAUTION!
The dispenser must be placed at least 10 cm clearance from the walls or other objects. It is desirable to keep at least 10 cm free space from its both sides. The unit should not be exposed to direct sunlight or close to other source of heat.
Before first use or if the appliance has not been used for a long time, purify the water tank by pouring and draining with clean water at least 2 times.
Do not switch the dispenser on without being putted full bottle with water. If you switch it on without a bottle with water, it can cause overheating and damage.
Place the water bottle on the dispenser. Once the bottle is placed, press the hot water tap until the water flows. When this happens in the tub with water may occur air bubbles, so the water container is full with water and no air and is ready for use. Do the same with the cold water tap. This operation must be done each time the tube with water is changed or when the containers are empty for some reason.
Plug the unit into the power supply.
Turn the hot water switch to “ON” position and the red indicator light illuminates. Turn the cold-water switch to “ON” position and the green indicator light illuminates.
When the red light goes off, respectively, the desired temperature in a container of warm water has reached 90 ° C. If after using the temperature falls below 80 ° C, the appliance starts heating up again and the red-light flashes.
When the green light goes off, respectively, the desired temperature in a container of cold water reached 6° C. When the temperature rises above this temperature, the appliance starts to cool again and the green light flashes.

NOTE: always drain the water of the dispenser when disconnecting from the mains for a long time.

HYGIENIC MAINTENANCE

Disconnect the dispenser from the power source.
Do not attempt to clean the water tanks with any cleaning product. Clean only with pure water.
Clean the exterior of the dispenser with a damp cloth.
When you change the bottle clean the device that holds the tube for water with a damp cloth.

WHAT TYPE OF WATER YOU CAN USE

Do not use water from the water network while using your dispenser. This is important for your health and for the smooth operation of the dispenser.
When you will not use the dispenser for a long time, unplug it from the mains drain the whole water from it and clean the water tank with cold water. Stagnant water causes deposits in the reservoir, which is difficult to clean. Cover the appliance to prevent dust.

ADDITIONAL INSTRUCTIONS FOR USE

When working with the appliance NEVER:
• Place the bottle on the dispenser without removing the protective sticker of the plastic tape;
• Pour other liquids or water from the water network;
• Change the wiring diagram of the dispenser or fuses;
• Try to disassemble the dispenser alone;
• Use the dispenser or bottle as a stand for food, plants and more.;
• Tap water taps with dirty hands;
• Pour other drinks in the bottle;
• Allow dispenser connected to the electricity if the bottle is empty;
• Leave dispenser without a bottle on it;
• Move or tilt the dispenser when a bottle is placed on it;
• Use abrasive, harsh, or scented detergents on the external surfaces of the dispenser.
WARNING!
Hot water flows from the red tap during normal use, which can lead to serious burns. Use it with caution.
Young children should not be left unattended near the appliance.
When using the appliance, always:
• Call the authorized service when there is unproper work or noise from the dispenser;
• Clean the drip dispenser tub regularly;
• Keep the full and empty bottles in a cool, dark place.

STORAGE

Turn off the appliance if not used for a long time, protect it from dust or storing it in its packaging in a dry and clean place.
The appliance is class of protection against electric shock CLASS I
The symbol means that the product should not be disposed of with household waste in order to avoid environmental contamination and human injury. Take the appliance to a specialist recycling center for electrical appliances.

MANUFACTURER AND IMPORTER:
Keten LTD.; VAT: BG123670208; fl. 7, 39 Vladimir Vazov blvd., 1836, Sofia, Bulgaria
Phone: +359 2 8691023;
Fax: +359 2 8691025;
e-mail: sales@keten.bg;
www.keten.bg