Alto Professional Stealth 1 Mono UHF XLR Wireless Audio System Instructions
- June 14, 2024
- ALTO PROFESSIONAL
Table of Contents
Alto Professional Stealth 1 Mono UHF XLR Wireless Audio System
Instructions
- Connect the XLR Input of the Transmitter to the output of a microphone, mixer, etc. Keep the volume on the connected device to its minimum settings, if applicable.
- Connect the XLR Output of the Receiver to the input of a powered loudspeaker, mixer, etc.
- Press and hold the Set button on the Transmitter to power it on.
- Press and release the Set button on the Transmitter to cycle through and select one of up to 16 available UHF channels* (0–9 and A–F). The Channel LED Display will light up and display the current channel as you press the button. If this Set button is not pressed for 3 seconds, the display will go dark.
- Press and hold the Set button on the Receiver to power it on.
- Press and release the Set button on the Receiver to cycle through and select the same UHF channel that has been selected on the Transmitter.
- Turn on your input and output devices and adjust the volume to hear the audio signal. If you hear noise in the signal, change to a different channel until a clean signal comes through.
- To power the Transmitter and Receiver off, press the Set button so the Channel LED Display turns on, and then press and hold the Set button until the device powers off. Note: Crosstalk may occur when operating multiple Stealth 1 systems on adjacent channels. If you encounter crosstalk, please adjust your units so they are operating on non-adjacent channels.
Please contact our friendly support team for assistance – amzsupport@altoprofessional.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>