4smarts SkyBuds Lucid Wireless Headset User Manual

SkyBuds Lucid Wireless Headset
User Manual Wireless Headset
SkyBuds Lucid
Thank You
for choosing a quality product from 4smarts

Safety Instructions

1.1 General precautions

• Do not drop the product or subject it to violent shocks.
• Have the product repaired by qualified personnel only.

1.2 Precautions for electrical products

• Protect the unit from dirt, moisture, overheating, extreme temperatures and use it only in dry rooms.
• Do not open the unit or operate it if it is damaged.
• Never use force when plugging in the unit or any adapters.
• Do not operate the unit outside the power limits specified in the technical data

1.3 Battery precautions

• Avoid storage, charging and use in extreme temperatures.
• Recharge the battery regularly (at least quarterly) if stored for a long time.
• Never open, damage, swallow or allow batteries to enter the environment as they contain toxic and environmentally harmful heavy metals.
• In the event of a leaking battery, do not allow the liquid to come into contact with the skin or eyes. In case of contact, rinse with plenty of water and consult a doctor.

Technical Data

Bluetooth version: 5.3
Range: Approx 15m
Bluetooth transmission power: 8dBm, 6.5mW max.
Battery: Lithium polymer
Battery capacity per headphone: 25mAh, 0.09Wh
Battery capacity of charging case: 250mAh, 0.92Wh
Charging port: USB-C
Charging port voltage / current: DC 5V/0.5A
Charging port power: 2.5W max.
Output power per headphone: 4mW
Headphone charging time: Approx. 1.5 hours
Charging time: Approx. 3 hours
Playback time headphones without charging cradle: 5 hours
Playback time headphones with charging cradle: 20 hours
Audio output sensitivity: 120dB max.
Microphone sensitivity: -90dBm max.
Frequency range of audio output: 20Hz-20KHz
Audio output impedance: 32Ω
Signal-to-noise ratio: 92dB
Voice control
Automatic pairing
Overcharge protection
Deep discharge protection
Short circuit protection

First Steps

3.1 Charging
Fully charge the product before using it for the first time. Connect the plug of the supplied cable to the USB-C charging port of the charging cradle. Connect the other side of the cable to a suitable charger. Always pay attention to the voltage and power  pecifications of your device. Wait until the product is fully charged before continuing. Disconnect the cable when charging is complete to conserve battery life.
Charging the charging case
While the charging case is charging using the USB cable, its LED status indicator flashes red.
As soon as the battery of the box is fully charged, the LED goes out.
Charging the headphones
The headphones automatically switch to charging mode when you place them back in the charging cradle, the charging case LED status indicator flashes green.
However, the charging cradle must have sufficient power for this.
Earphones LED effect
Charging completed: Red and blue lights out.
Turn on: Red and blue lights flash.
Turn off: The red light blinks three times.
Battery low: Blink red for 5 seconds.
Connection successful: Red and blue lights off.
Connection failure: The left red and blue lights flash quickly, and the right lights are off.
Connection interrupted: The red and blue light on the left flash rapidly and the right light is off.
3.2 Bluetooth connection
Open the charging cradle and take out the headphones. Go to the Bluetooth settings of your smartphone and search for “4smarts SkyBuds Lucid”.
3.3 General headphone controls
Turning on / off:
Once paired with your smartphone, the headphones will automatically turn on and off when you take them out of the charging cradle or put them back. They turn off after 3 minutes without Bluetooth connection.
Play/Pause:
While listening to music, twice touch the touch area to pause or resume playback.
Forward/Reverse:
To skip forward one track, triple-tap the right earpiece. Tap the left earpiece three times to skip to the previous track.
Volume control:
Long tap the right earpiece to increase the volume, long tap the left earpiece to decrease the volume. Repeat this process until the desired volume is reached.
Answering/ending calls:
Tap the touch sensor twice to answer an incoming call. Tap twice again to end the call.
Voice assistant:
Tap the touch area for a long time until the voice assistant of your smartphone responds.

Function notes

responds

Trouble Shooting

The connection does not work:
Make sure that the product:
– Is fully charged.
– Is within range of the device.
– Is not already connected to other devices (deactivate Bluetooth on other devices if necessary).
Make sure that your device:
– Is compatible with the Bluetooth version specified in the technical specifications.
– Has an active Bluetooth connection and is in pairing mode.
– Does not have any other active device connections.
Depending on the device and its software, the initial connection may take longer. Wait up to one minute, or try again in an environment with less or minimal radio traffic, if necessary.
Restart:
If the headphones lose connection or other problems arise try a restart.
If the headphones are connected and disconnect automatically, double-click the touch position to reconnect them.
The communication is not clear:
– Try again in a wind and reverberation free environment.
– Try connecting to another terminal.
– Make a call on another phone.
– If necessary, try again in an environment with less or minimal radio traffic.

Care and Maintenance

Use only dry, soft cloths for cleaning.

Warranty

4smarts GmbH accepts no liability or guarantee for damage resulting from improper installation, assembly and improper use of the product or failure to observe the operating instructions and/or safety regulations.

Disposal notification

Electrical and electronic devices as well as batteries must not be disposed of with household waste. The consumer is legally obliged to return electrical and electronic equipment as well as batteries at the end of their service life to the public collection points set up for this purpose.

Service and support

If the product is defective or in case of problems during installation, please consult your dealer oft he 4smarts product consulting via: https://4smarts.com/contact

Attestation of conformity

Hereby, 4smarts GmbH, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consul ted at www.4smarts.com.
Service Hotline
Monday – Friday: 9am-5pm
+ 49 (0)821 20708444
Email: customer-service@4smarts.com

Thanks for buying our product! We at 4smarts are sure it will serve you well.
Follow us on social media for news, customer support and to win great prizes.
See you there!
@4smarts_official
facebook.com/4smarts
IN linkedin.com/company/4smarts
**** All listed brands are trademarks of the corresponding companies.
Errors and omissions excepted, and subject to technical changes.
Our general terms of delivery and payment are applied.

References

• Kontakt - 4smarts onlineshop

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>