Convair CTH09 Tower Heater Owner’s Manual
- June 17, 2024
- Convair
Table of Contents
OWNER’S MANUAL
Convair Tower Heater CTH09
SAFETY
General Safety
Please read these instructions before using the heater and keep for future
reference.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction in using the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance. Do not poke anything through the ventilating slits.
Always use the heater in an upright position.
Stand it on a firm, solid, horizontal base (not on thick pile carpets).
WARNING: In order to avoid overheating, do not cover the heater.
Leave nothing hanging above or in front of the heater (e.g. clothes, curtains,
bedding, fabrics). Be sure that the back panel vent slots on the heater are
uncovered otherwise it will overheat. Clean these openings at regular
intervals to prevent airflow reduction (refer Maintenance section).
The heater surfaces are hot when in use. To avoid burns, keep bare skin away
from the top ventilation outlets. Leave plenty of room around the heater.
Do not use this heater outdoors, or on wet surfaces. Do not use the heater
near flammable areas or substances.
Electrical Safety
Connect the heater to a single 230 Vac, 10A socket only. Do not plug into
double adaptors or multi-outlet power boards. Do not use an extension cord to
operate this heater.
Make sure that the heater never comes into contact with water. Never position
the heater under a power outlet.
Never turn the heater on if the power supply cord is damaged or if the
heater’s casing is obviously damaged. If the power supply cord is damaged it
must be replaced by the manufacturer, a service agent or similarly qualified
persons in order to avoid a hazard.
Do not pull the heater along by the power cord or place the cord near the
heater’s surfaces.
Always uncoil the power cord completely before use. Use of extension cords is
not recommended.
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool. If the heater is to be used in a bathroom, ensure that switches
and other controls cannot be touched by a person in the bath or shower.
Do not use this heater with a programmer, timer, separate remote-control
system or any other device that switches the heater on automatically, since a
fire risk exists if the heater is covered or positioned incorrectly.
Always turn the heater off and unplug from the power socket when not in use.
Safety Device
To avoid overheating problems the inbuilt safety device will interrupt
electricity in the event of the heater overheating.
If this should happen:
- Check that the heater is positioned correctly, not close to any furnishings.
- See that there is no dust or other obstacles blocking the vent slots.
- Clean the vent slots if necessary.
The heater is also equipped with a ‘tip-over’ switch, which will turn off power to the heater elements if it should fall over.
ASSEMBLY
COMPONENTS LIST
- Control panel
- Display Panel
- Front Grille
- Handle
- Air inlet grille & filter
- Power Isolation Switch
- Base (Locking nut not shown)
- Remote control
ASSEMBLY
Unpack the heater and check that you have all of the components.
Turn the heater upside down and remove the plastic Locking nut. Assemble the
Base onto the heater and fix into position with the Locking nut.
Note: Ensure the nut is tight to avoid shaking of the heater.
REMOTE
When the heater power is on, the remote control can be used to operate the
heater from up to 4m away.
If there are two or more heaters within this distance all will be operated by
the same remote control.
Replacing the battery
Release battery slide by pressing on the tab at the bottom of the remote.
Remove the battery and replace with an equivalent CR2032 type battery.
Note: Your remote control will be supplied with a battery.
OPERATION
DISPLAY
Control Panel Remote Control Display Panel OPERATION
- Ensure the heater is plugged into a mains power outlet and is switched on.
- Turn the isolation switch on (I), at the back of the heater, to begin use. The heater will make a ‘beep’.
Turning on/off
-
Press the ON/OFF button, on the heater or remote, to turn the heater on. The room temperature will be shown on the display.
Note! The heater will start in the last operating mode used. -
To turn the heater off press the ON/OFF button.
Note! The fan will continue to run for a further ten (10) seconds, after the heater is turned off.
Swing function
The heater can be set to oscillate from side to side to better distribute heat
within the room.
- Press the SWING button to turn swing mode on & off. The swing indicator on the display panel will be lit when swing mode is on.
Heat settings
- The heat setting can be switched between low heat (1400W) and high heat (2400W) by pressing the HEATER button.
Temperature control
The heater has a temperature sensor.
When the room temperature reaches the set temperature, the heater will
automatically switch to standby mode. Once the room temperature has cooled by
2°C the heater will automatically turn ON. The heater will not judge the
temperature within 10s of the heater turning on.
To set a desired temperature:
- Press the SHIFT button twice to enter into temperature setting mode. The temperature/ timer display will begin flash.
- Press UP and DOWN to set the desired temperature. Pressing the UP and DOWN buttons will increase and decrease the temperature by 1°C increments. Temperature set range is 15°C to 35°C.
- Press the SHIFT button or wait 4 seconds to confirm the set temperature. The room temperature will again be displayed.
- Reset the temperature by re-entering the temperature setting mode and using the UP and DOWN buttons to set the desired value.
Timer
- Press the SHIFT button once to enter into timer setting mode. The temperature / timer display will flash on the display panel.
- Press the UP and DOWN buttons to set the time before the heater automatically turns off. Pressing UP and DOWN will increase and decrease the time by 1 hr increments. Timer range is 1-12hrs.
- Press the SHIFT button or wait 4 seconds to confirm the timer setting. The display will now cycle between the current room temperature and the timer countdown.
- Reset the timer by re-entering the timer setting mode and using UP and DOWN to set a desired time.
- To cancel the timer setting, set the timer to zero (00) hours or turn the heater off.
CLEANING AND STORING
Make sure that the device is switched off before cleaning.
Wipe the surface of the heater by using a clean damp cloth.
Do not use chemical liquids when cleaning the heater.
Do not submerge the heater in water.
Make sure that the heater has cooled down completely before storing. Storing
in its original packaging is highly recommended.
Cleaning the filters
WARNING! Ensure that the heater is switched off at the supply mains
before removing filter panel.
Remove the filter and clean using a vacuum cleaner or tap the panel lightly to
remove loose dust and dirt and then rinse under running water (no hotter than
40°C).
Dry thoroughly before replacing.
Note! To maximize the efficiency of the heater, clean the filters
regularly.
Note! Never operate the heater without the filters and air inlet grille
installed.
Waste electrical products must not be disposed of with household waste.
This product should be taken to your local recycling centre for safe
treatment.
WARRANTY
In this warranty:
We or us means Seeley International Pty Ltd. ABN 23 054 687 035, and our
contact details are set out at the end of this warranty;
You means you, the original end-user purchaser of the Goods;
Supplier means the authorised distributor or retailer of the Goods that sold
you the Goods in Australia; and Goods means the product, unit, appliance or
equipment which was accompanied by this warranty and purchased in Australia.
Our Goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the Goods repaired or replaced if the Goods fail to
be of acceptable quality and the failure does not amount to a major failure.
In addition to any rights and remedies that You may have under the Australian
Consumer Law or any other law, subject to the terms of this warranty, We
provide the following warranty:
-
If, during the first 24 months from the date of first retail purchase (Warranty Period), the Goods upon examination prove defective by reason of improper workmanship or material, We will replace the Goods or any part thereof without charge. We may substitute with any similar Goods (including a panel heater, or a portable heating product of a different size or shape), even if it is not on our current price/equipment list. Alternatively, we may arrange a refund of the purchase price you paid.
-
We are under no obligation to replace the Goods under clause 1 if the Goods have not been used only for personal, domestic or household purposes and have not been installed/mounted (if relevant), operated, and maintained in accordance with the instructions in the Owner’s Manual. The addition of any third party device or the removal or the alteration of any of our components will void this warranty. In addition, the warranty granted under clause 1 does not apply to:
• Adjustments necessary due to misuse of the appliance,
• Normal user maintenance,
• Setting of controls,
• Transit damage, or
• Damage caused by user misuse, tampering, or failure to observe the care and special provisions in the instructions. -
The warranty granted under clause 1 is limited to replacement only. As far as the law permits, We will not be liable for any consequential loss suffered through, or resulting from, the non operation, or ineffective operation of the Goods. The warranty granted under clause 1 does not cover damage to the Goods or other loss resulting from acts of God.
-
No other person, firm or corporation is authorised by us to offer or give on our behalf any other or greater warranty than that given under this warranty. The benefits conferred by this warranty are in favour of You and any person deriving title to the Goods through or under such person and are intended to be separate from and additional to all other rights and remedies that they may have in law in respect of the Goods.
-
We are not responsible in any way for any failure and/or inadequate performance of the Goods which arises from or is connected to the use in the Goods of non-genuine spare parts. We strongly recommend that only spare parts supplied or approved by us are used in the Goods.
-
In order to claim under the warranty granted under clause 1 You must within the Warranty Period return the Goods to the Supplier at the place of purchase together with the proof of purchase.
-
Alternatively, you may claim under the warranty granted under clause 1 by within the Warranty Period returning the Goods to us at the address below together with: (i) a covering letter which states your name and address, daytime telephone number, and model and serial number of the goods, (ii) the legible and unmodified proof of purchase, which clearly indicates the name and address of the original retailer, the date and place of purchase, and the product name or other product serial number, and (iii) a copy of the completed Warranty Information below.
-
This warranty does not cover the cost of claiming under the warranty, it is your responsibility to cover all forwarding and freight costs incurred in returning the Goods to the Supplier at the place of purchase or us.
-
This warranty is only valid and enforceable in Australia.
Our liability under this warranty is limited to the extent permitted by law.
That is, to the extent that it is fair and reasonable, if the Goods are not of
a kind ordinarily acquired for personal, domestic or household use or
consumption, your remedies associated with any failure or defect of the
Product will be limited to:
(a) the replacement of the Goods or the supply of equivalent goods;
(b) the repair of the Goods;
(c) the payment of the cost of replacing the Goods or of acquiring equivalent
goods; or
(d) the payment of the cost of having the Goods repaired and subject to the
terms and conditions included in this warranty.
For technical assistance before returning the product please contact: 1300 650
399
Please retain your receipt as proof of purchase. Every request for warranty
must be accompanied by proof of purchase.
Complete the following for your records:
Serial Number
Product Convair Tower Heater
Model: CTH09
Purchased from
Date purchased
You can also register your warranty with us on our website.
Service Department
Seeley International Pty Ltd
112 O’Sullivan Beach Road
Lonsdale, South Australia 5160
Technical assistance in Australia: 1300 650 399
Website: www.seeleyinternational.com
PRIVACY NOTICE
Seeley International Pty Ltd ABN 23 054 687 035 will use the personal
information you provide us with to provide warranty support for the product
you have purchased and to inform you about other products and services. If you
choose not to supply us with the information requested, we may be unable to
provide you with warranty support. We may also disclose your information to
third parties, such as related entities; retailers, distributors, service
agents and contractors who are affiliated with us; or marketing or market
research companies. If you would prefer not to receive direct marketing
communications from us, please follow the instructions to “unsubscribe” which
will be included in the direct marketing communications we send you, or
contact our Privacy Officer using the details set out below. While we do not
currently transfer personal information to overseas recipients or store
personal information overseas, if we transfer your information to third
parties who do so, we will take reasonable steps to ensure that the overseas
recipients do not breach the Australian Privacy Principles. By registering
your warranty, you consent to having your personal information used in this
way. Please read our Privacy Policy on our website
www.seeleyinternational.com for further
explanation of how we collect, use, hold and disclose personal information,
and how you may access and seek correction of your information. It also sets
out how you may complain about a breach of the Australian Privacy Principles,
and how we will deal with your complaint. You may contact us at: Privacy
Officer, Seeley International Pty Ltd, 112 O’Sullivan Beach Road, Lonsdale,
South Australia 5160.
It is the policy of Seeley International to introduce continual product
improvement.
Accordingly, specifications are subject to change without notice.
Please consult with your dealer to confirm the specifications of the model
selected.
Warranty Service
Australia 1-300-650-399
seeleyinternational.com
Documents / Resources
|
Convair CTH09 Tower
Heater
[pdf] Owner's Manual
CTH09 Tower Heater, CTH09, Tower Heater, Heater
---|---
References
- Seeley International - World Leading Air Conditioners
- Seeley International - World Leading Air Conditioners
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>