Jungborn 10259433 Floriel White Rimless Toilet Combination Instruction Manual
- June 12, 2024
- Jungborn
Table of Contents
10259433 Floriel White Rimless Toilet Combination
Instruction Manual FLORIEL
Art. 10259433 . Art. 10557255
Art. 10654340
Version: 03/23
10259433 Floriel White Rimless Toilet Combination
Assembly Instructions Rimless washdown two piece toilet Read the instructions carefully before use and keep them for
future reference! For daily cleaning use only commercial bath cleaners. Lime
scale and soap residue can be removed with commercial lime remover or vinegar
cleaners.
NOTE: We recommend using an underlay to protect the ceramic and tiles
during installation. Installation situation: Mark on the floor the centre of
the mounting holes found on the exterior of the WC ceramic. Place the soundproofing pad along
the line
Connect the two marks by drawing a
straight line.
Determine the position of the
centre holes, width range (within tolerance ): X=6.9cm±1cm
Drill 2 holes into the marks and
insert the dowels. Screw the L-shaped fixing bracket in place.
Position the toilet.
Connect the toilet with the
L-shaped fixing bracket with (6) and (7).
Cover the screw with a cover cap
(5).
Horizontal outlet
Vertical outlet
Assembly instructions cistern and valves
“R&T filling valve”, A1420 and A2706 (included in the scope of delivery)
Install the base of the mounting
screw(13b) on the toilet pan.
Put the cistern on the pan and
make sure the mounting holes in the tank match the screw base on the pan
perfectly, then move the pan and tank against the wall at the same time, after
that install the screws at the same time. Fasten the cistern using the included bolt.
Install the flush valve (outlet
valve).
Compatible with : “Geberit
filling valve”, type 380 and type 290 (not included in the scope of
delivery)Type 380+Type290
Assembly instructions WC seat (Spare part available #10329391) Adjust the folding pin (7) and
bolt (4) to the parallel direction, then plug them into the designated holes
on the toilet. Tighten the bolt.
Screw the stainless steel screws
(4) to the mounting plate (2) so that the mounting plate can still move
easily.
Push the WC seat onto the pins of
the mounting plate (2) until it snaps into position.
Align the WC seat on the toilet.
Align the WC vertically towards
the top. Next, pull the seat up vertically to remove it.
Now, screw the mounting plates
(2) tight.
Now, slide the cover cap (1) onto
the mounting plate (2) before pushing the toilet seat back onto the pins so
that it snaps into place.
HORNBACH Baumarkt AG
Hornbachstrasse 11
D-76879 Bornheim
www.hornbach.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>