Skydio X2D 5 GHz Channel Selection Instructions
- June 4, 2024
- Skydio
Table of Contents
Skydio X2D 5 GHz Channel Selection
Instructions
X2D 5 GHz Channel Selection
When set to auto, your Skydio X2D will automatically monitor signal interference and move to a clearer channel to improve wireless transmission signal quality during flight. Manually select your radio frequency channel to avoid congestion from other signals. Channel Selection will persist across flights and power cycles. Requires minimum vehicle software release version 19.4.18 and Enterprise Controller software release version 20.1.30.
Step 1 – Select settings
Step 2 – Select the Drone tab
Step 3 – Select Channel Selection
Standard 5 GHz WiFi channels that correspond to the following frequencies:
Auto
36: 5180 MHz
40: 5200 MHz
44: 5220 MHz
48: 5240 MHz
149: 5745 MHz
153: 5765 MHz
157: 5785 MHz
161: 5805 MHz
165: 5825 MHz
Step 4 – Select the INFO menu
Step 5 – Select High Power Mode
Step 5 – Enable High Power Operation
- Enabling High Power operation would ensure you achieve the maximum range and signal strength available for the selected channel.
- Skydio recommends leaving the Channel Selection set to Auto for best results.
- If Auto does not result in a clear channel, select either 161 or 165.
- Maintain visual line of sight on the drone.
- Point the controller cover in the direction of the drone to maximize the connection.
- Check radio signal strength indicator periodically during flight.
- If you are unable to acquire an RF signal after manually selecting your channels, it is likely your RF signal is being jammed.
- In the event of an RF signal loss, your drone will default to the emergency behaviors you set.
- If flying in Attitude Mode, the drone will perform an emergency landing in place.
WARNING: The controller antenna is located in the cover and should be oriented in the direction of the drone to maximize RF signal quality.
© 2023 Skydio, Inc. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>