POWER-LITE LED-DL35W LED Cob Downlight Installation Guide
- June 12, 2024
- POWER-LITE
Table of Contents
INSTALLATION MANUAL
LED COB
DOWNLIGHT
LED-DL35W
LED-DL45W
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following;
- Read allinstructions.
- Licensed electrician for installation only
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings
- 7o avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Instruction
Tab 1: Ceiling cutout reference table.
| Downlight dia (inch) | 2 | 2.5 | 3 | 3.5 | 4 | 5 | 6 | 8 | 10 |
|---|---|---|---|---|---|---|---|---|---|
| Ceiling Cutout (mm) | 60-65 | 68-75 | 90-95 | 100-T10 | 120-130 | 140-150 | 160-170 | ||
| 200-210 | 230-260 |
NOTE: Before installation, please check the IP label on the luminaire to choose the right place to install
| IP20/IP40 | Indoor use only, do not use in wet or damp place. |
|---|---|
| IP44/IP54 | Suitable for indoor areas including bathrooms and covered/sheltered |
areas such as porches.
IP65| Suitable for outdoor areas, not suitable for water immersion.
NOTE: Before installation, please check the information of driver as below.
| Non-dim | Can not be used with any dimmer. |
|---|---|
| Triac dim | Compliable with recommended TRIAC dimmers, dimming range 8-100%. |
| 0/1-10V | Only work with 0/1-10V dimming system, dimming range 8-100%. |
| DALI | Only work with DALI dimming system, dimming range 8-100%. |
Installation Procedure
WARNING
- Switch off before installation.
- .Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly.
Downlight with external driver
For the product with Slide Switch of Color Selection, pledse select the light colour (CW/NW/Ww) before installation,
- 0pen a hole according to the cutout size of led downlight
- Use screw-diver to open the diver terminal cover, feed the main AC wire L N in terminal block respectively, then fix the cover back
- Connect the downlight with driver, hold back the spring clip then push the downlight into the hole.
- Make sure the downlight fixed tightly in ceiling, turn on the power (Fig 1).
Downlight with internal driver
For the product with Slide Switch of Color Selection, please select the light color (Cw/ NW/wWw) before installation.
- Open a hole according to the cutout size of led downlight.
- Use screw-driver to open the diver terminal cover on the back of downlight, feed the main AC wire L’N.in terminal block respectively, then fix the cover back
- Hold back the spring clip then push the downlight into the hole.
- Make sure the downlight fixed tightly in ceiling, turn on the power (Fig 1).
Warning: Production modification and improper installation are not valid for warranty.
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>