POWER-LITE LED-DL10WCOB LED COB Downlights Installation Guide
- June 12, 2024
- POWER-LITE
Table of Contents
POWER-LITE LED-DL10WCOB LED COB Downlights Installation Guide
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- IP54 for indoor use only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Instructions
The fitting has an insulating ceiling type IC-4 rating. Building material and
thermal insulation that can safely be exposed continuously to temperatures up
to 90℃ may abut and cover the luminaire.
If the building material cannot meet this condition, the minimum clearance of
25mm is required. See Figure 1 :
Tab 1: Ceiling cutout reference table.
| Downlight dia (inch) | 2.5 | 3 | 4 | 6 | 8 |
|---|---|---|---|---|---|
| Ceiling Cutout (mm) | 70-75 | 90 | 120 | 160 | 190 |
NOTE: Before installation, please check the IP label on the luminaire to choose the right place to install.
P20/IP40 Indoor use only, do not use in wet or damp place.
IP44/IP54 Suitable for indoor areas including bathrooms and
covered/sheltered areas such as porches.
IP6 Suitable for outdoor areas, not suitable for water immersion.
NOTE: Before installation, please check the information of driver as below.
Non-dim Can not be used with any dimmer.
Triac dim Compliable with recommended TRIAC dimmers, dimming range
8-100%.
Installation Procedure
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
- Risk of overheating of fire if the clearance distances are compromised.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly
Downlight with internal driver
Please select the colour temperature (CW/NW/WW) before installation.
-
Cut a hole according to the cutout size of led downlight.
-
Use screw-driver to open the driver terminal cover on the back of downlight, feed the main AC wire L. N. in terminal block respectively, then fix the cover back.
-
Hold back the spring clip then push the downlight into the hole.
- Make sure the downlight fixed tightly in ceiling, turn on the power (Fig 1).
RISK OF FIRE – Required clearance from structural members and building
elements
SCB=25mm HCB=25mm
Warning:
Input wire diameter ≥0.75mm²；
Product modification and improper installation void the warranty!
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>