Instant Care FS312 IC Wireless Fall Detector Instructions
- June 12, 2024
- INSTANT CARE
Table of Contents
Instant Care FS312 IC Wireless Fall Detector
Model#: FS312
Fall Sensor – FS312
This Fall Sensor is designed for a user to push the button for help at any
time. It can also automatically1 activate an emergency alarm if it detects a
fall in the event that the user is unable to trigger an alarm by pressing the
button.
Usage Recommendation
- For best results, the Fall Sensor should rest at the center of the user’s breastbone. Adjust the lanyard length using the sliding clasp so that the device rests as the center of the user’s breastbone.
- Wear the Fall Sensor on the outside of all articles of clothing.
- Carefully place the Fall Sensor on a table or nightstand when you are not using it in order to avoid activating an alarm.
- The Fall Sensor may be worn in the shower (IP45 rated).
Identifying the Parts
- Emergency Button Pressing the Emergency Button for 0.5 sec will activate the Control Panel, causing it to dial an emergency call or alarm (CID event code: 101).
LEDs
- ED Off =Standby Mode
- 1 Red Flash= Replacement Battery Inserted
- 1 Red, then 1 Green Flash =First button press after replacing the battery
- 1 Green Flash= Transmitting with Good Battery
- 1 Red Flash= Transmitting with Low Battery
Lanyard
- The lanyard length is adjustable by holding this piece and pulling the loop to increase or decrease the lanyard length.
Battery Compartment Cover
- When replacing the battery, ensure that the positive side (+) of the battery is facing outward.
- After replacing the battery, press and hold the Emergency Button until you see the LED flash RED then GREEN.
Low Battery Detection and Supervision
- Fall Sensor features Auto Low Battery detection and Supervision.
- When a battery is below the low battery threshold, the Fall Sensor will automatically send a low battery supervisory message every two hours.
Testing
- When testing, do not activate the Fall Sensor twice within a 10-second interval.
Battery & Electrical Specifications
- Frequency: 312MHz
- Battery: CR2477, 3V 1000mAh
- Battery life: 2yrs with an average of one button push per day.
- Open Field Range: Approximately 200 ft.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance may void the user’s authority
to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC Statement
- This Class [B] digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada. Statement :
- This device complies with RSS-247 and ICES-003 of the Industry Canada Rules. Operation is subject to the following two conditions :
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation of this device.
IMPORTANT NOTE
IC Radiation Exposure Statement
- This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>