INSTANT CARE Mini-Halo BLE-1 Trelawear Pendant User Manual
- June 5, 2024
- INSTANT CARE
Table of Contents
Treadwear Pendant User’s Manual
Model #: Mini-Halo BLE-1
-
Identifying the Parts
1. Emergency Button -
Learning-in the Trelawear Pendant
Press the Emergency button, a radio signal will be transmitted to the Control
Panel. Please refer to the learn-in procedure of your Control Panel for further instruction. -
Operation
➢ To dial Emergency Line:
Press and hold the Emergency button for 2 seconds and release. The device will transmit the message to the Control Panel.
➢ Sleep Mode:
-The Halo Transmitter ships in “Sleep Mode” to conserve battery life
-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode -
Battery & Electrical Specifications
➢ Frequency: 2.4GHz
➢ Battery: CR2032, 3V 230mAh
➢ Battery life: Typical life expectancy of 3 years at an average use rate of one activation per day.
➢ Open Field Range: Approximately 150+ ft
➢ Low battery status: when the battery voltage is below the threshold, the Transmitter will Indicate a low battery by sending a low battery supervisory message to the Control Panel once every 24 hours.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance may void the user’s authority
to operate his equipment. (Example – use only shielded interface cables when
connecting to computer or peripheral devices)
FCC Section 15.105 Information to the user.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC ID: XO8-HALOMBLE-A