Crate Barrel Emmer Desk with Power Outlet User Manual
- June 12, 2024
- Crate Barrel
Table of Contents
Crate Barrel Emmer Desk with Power Outlet
INTRODUCTION
This page lists the contents included in the box. Please take time to identify the hardware as well as the individual components of the product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage. Please follow the assembly instructions closely. Improper assembly can result in personal or property damage.
PARTS AND TOOLS
INSTALLATION INSTRUCTIONS
NOTE: Please do the following if the unit is not level.
Method To Change Position Of Power Strip
WARNING
Serious or fatal crushing injuries can occur from furniture tip-over. To help
prevent tip-over, install tip restraints per instructions. To further reduce
the risk of serious injury and death from tip-overs:
- Place the heaviest items in the lowest compartments or drawers.
- Unless specifically designed to accommodate, do not set TVs or other heavy objects on top of this product.
- Never allow children to climb or hang on drawers, doors, or shelves.
- Never open more than one drawer at a time.
The use of tip-over restraints may only reduce, but not eliminate, the risk of tip-over.
- For safe mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc).
- Mount to wood studs whenever possible.
NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your local hardware store.
Wall Mounting Instructions
- Noting the location of the product’s mounting plate(s), mark and drill holes in the wall for mounting plate(s). Drill pilot holes into marked positions and into a wall stud.
- NOTE: if wall studs are not available, drill holes slightly smaller than the drywall anchors and insert each anchor until its flange is flush with the wall.
- Using a screwdriver, secure mounting bracket(s) to the wall stud or drywall anchors with screws provided.
- Position the product in the final location, and secure it to the wall by lacing one end of plastic tie(s) through both the wall and product mounting plates and through the other end, pulling tightly to remove slack. Do not over-tighten.
Cleaning and Care
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish. It is recommended to use coasters to protect the surface from heat and water. Do not leave spills unattended. Periodically check and tighten hardware as necessary.