Gymax GYM09703 Metal Raised Garden Bed Kit Planter Raised Garden Boxes Outdoor Instructions
- October 30, 2023
- GYMAX
Table of Contents
USER’S MANUAL
Elevated Oval Garden Bed
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
GYM09703 Metal Raised Garden Bed Kit Planter Raised Garden Boxes Outdoor
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE!
NOTICE
Please retain these instructions for future reference.
- Do not stand on or use any part of this item as a step ladder.
- Firmly secure all bolts, screws, and knobs before use
- Reconfirm that all bolts, screws, and knobs are secure every 90 days.
- Be aware that some parts are heavy and have sharp edges.
- If any parts are missing, broken, damaged, or worn, stop using this product until repairs are made and/or factory replacemernt parts are installed.
- Do not use this item in a way inconsistent with the manufacturer’s instructions.
TOOLS REQUIRED
HARDWARE
PARTS
PRODUCT ASSEMBLY – A
-
Connect two part A end panels with five part 1 screws and five part 2 washers, then secure with five part 3 wingnuts. Leave the bottom connector holes open.
-
Connect two part A end panels with five part 1 screws and five part 2 washers, then secure with five part5 wingnuts. Leave the top connector holes open.
Overlap the two end panel assemblies & align the empty connector holes, then secure with one part 4 screw, one part 2 washer, and one part 3 wingnut.
Repeat steps 1 & 2 to assemble a second end panel. -
Interlock the bottom of the two end panel assemblies with two part B side panels, twenty part 1 screws, and twenty part 2 washers, then secure with twenty part 3 wingnuts. Leave the top Connector holes open.
-
Interlock the top of the two end panel assemblies with two part B side panels, twenty part 1 screws, and twenty part 2 washers, then secure with twenty part 3 wingnuts. Leave the bottom Connector holes open.
Align the empty connector holes, then secure with four part 4 screws, four part 2 washers, and four part 3 wingnuts.
-
Cut the part 5 rubber bumper into four pieces equal to the straights/curves of the garden bed, then place them on the top edges.
PRODUCT ASSEMBLY – B
-
Connect two part A end panels with five part 1 screws and five part 2 washers, then secure with five part 3 wingnuts. Leave the third connector holes open. Repeat to assemble a second end panel set.
-
Interlock the two end panel assemblies with two part B side panels, twenty part 1 screws, and twenty part 2 washers, then secure with twenty part 3 wingnuts. Leave the third connector holes open.
Repeat steps 1 & 2 to assemble a second garden bed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>