Vaxcel C0265 Ravenswood 3 Light Flush Mount Instruction Manual

Vaxcel C0265 Ravenswood 3 Light Flush Mount

Product Information

The product is a ceiling fixture with model number C0265. It requires a maximum of 60W Type A/ST bulbs (not included) and comes with a hardware package that includes a mounting strap unit (A), mounting screw (B), wire connector (C), and finial (D). The fixture dimensions are 6-3/4 inches for the mounting strap unit (A) and 13 inches for the mounting screw (B).

Product Usage Instructions

1. Before installation, consult local electrical codes for wiring and grounding requirements.
2. Turn off the power at the fuse or circuit box.
3. Attach the mounting strap unit (A) to the outlet box using two mounting screws (B).
4. Connect the house ground wire to the green ground screw on the mounting strap unit (A).
5. Attach the wire connector (C) to the fixture wire and the house wire.
6. Connect the fixture ground wire to the house ground wire.
7. Insert the threaded pipe into the center hole of the ceiling pan and secure it with the finial (D). The depth of the threaded pipe may need to be adjusted to properly fit the finial.
8. Install three medium base bulbs (not included) with a maximum wattage as indicated on the relamping label at the socket area or packaging.
9. Turn on the power at the fuse or circuit box.

If any parts are damaged or missing, the Assembly Kit 6486MM can be ordered, which includes a mounting strap unit (A), mounting screw (B), wire connector (C), and finial (D).

WARNING
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE

1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS

Hardware Package (included):

Installation Steps

Turn off the power at fuse or circuit box

1. Attach the mounting strap unit (A) to the outlet box by using two mounting screws (B).

2. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

3. Connect the hot wire (black insulation) from the fixture to the black wire from the power source.

4. Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.

5. Attach the fixture ground wire (bare wire) to the mounting strap unit (A) with the green ground screw. Then, depending on local code, connect it to the house ground wire with the wire connector (C).

6. Carefully put all of the wires back into the outlet box.

7. Attach the ceiling pan to the mounting strap unit (A) by inserting threaded pipe into the center hole the ceiling pan and secure it with the finial .
   NOTE : Depth of threaded pipe may need to be adjusted to properly fit the finial.

8. Install 3 x 60W max.medium base bulbs (not included). Check relamping label at socket area or packaging for maximum wattage allowed.

The following parts are available for re-order if damaged or missing

Spare Parts List

DIMENSIONS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>