Waterdrop V003 Water Filter Cartridges Instruction Manual
- June 14, 2024
- Waterdrop
Table of Contents
Model: WD-C07
Classic jug filter cartridge
In accordance with EN 17093;
Average Chlorine Reduction 86%
Filtration Capacity: 150L
Tested and Certified by NSF International against NSF/ANSI Standard 42 in
model
ECF-7016XX-07BZ/ECF-7017XX-07BZ/ECF-7019XX-07BZ for the reduction of the
claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (<0.25%
lead).
Performance data sheet
System Model No : ECF-7016XX-07BZ/ECF-701 7XX-07BZ/ECF-7019XX-07BZ
Substance reduction
The system has been tested and certified by the NSF International according to NSF/ANSI Standard 42 and NSF/ANSI Standards 372. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.
Substance| Inf. Average| NSF Specified
Challenge
Concentration| Ave. % Reduction(%)| Average Product Water
Concentration| Max Permissible Product Water Concentration| NSF
Reduction
Requirements| NSF Test
Report
---|---|---|---|---|---|---|---
Chlorine Taste and Odor| 2.2 mg/L| 2.0mg/L±1096| 81.0%| 0.05 mg/L| N/A| ≥5096|
J-00355923
System to be used with municipal or well water sources treated and tested on
regular basis to ensure bacteriological safe quality. Do not use with water
that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Testing was performed under standard laboratory conditions, actual performance
may vary.
NOTICE
As for a pitcher without a flow restrictor, DO NOT install the valve insert; if your pitcher has the flow restrictor, please install the valve insert according to the instructions to ensure normal use of the product.
How to fit the VALVE INSERT?
- Remove the old filter.
- Find the flow restrictor.
- Insert a valve into the bottom of the flow restrictor from the outer side by aligning three claws of the valve to three water outlets.
- Insert the filter and proceed as normal.
Note: please make sure that three claws of the valve are aligned to three hollowed-out water outlets of the flow restrictor, and insert the valve firmly in place.
Instructions
Replacement for Brita® Laica® and many other brands.
Place the filter into a bowl of clean cold tap water, push gently down until
submerged and bubbles of air are released. Leave for 10 minutes.
Fit the filter into your filter jug as per the manufacturers instructions.
Replace hopper and fill with cold water, allow to filter through and discard.
Repeat this step twice more.
Your filter is now ready to use.
It is advised that all filtered water is stored in the refrigerator and
discarded after 48 hours if not consumed.
Qingdao Ecopure Filter Co., Ltd.
Tel: 1-888-352-3558 (U.S.)
E-mail: service@waterdropfilter.com
Add.: No.13, Yishengbai Road Jimo, Qingdao, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>