VAXCEL T0711 Outdoor Wall Light Instruction Manual

October 30, 2023
VAXCEL

230210
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
T0711 / T0712

WARNING: Turn off the main power at circuit breaker before installing fixture.
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE:

  1. Before installing, consult local electrical codes for wiring and grounding requirements.
  2. Read and save these instructions.

Hardware Package (included):

VAXCEL T0711 Outdoor Wall Light -

VAXCEL T0711 Outdoor Wall Light -fig1

Installation Steps

Turn off the power at fuse or circuit box

  1. Unscrew the two set screws (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.

  2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B).
    Note: Make sure that two set screw holes are lined up horizontally to make the fixture level.

  3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
    • Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
    • Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
    • Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with green ground screw.
    Then, depending on local code, connect it to the house ground wire with the wire connector (C).
    Carefully put all of the wires back into the outlet box.

  4. Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.

  5. Attach the glass shade to the fixture from the fixture bottom hole, then rotate it carefully until it is locked in place.

  6. Attach the backplate of the fixture to the mounting plate unit (A) and then secure it with two rubber pads (E) and the two set screws (D).
    Note: With silicone caulk compound, caulk completely around where the backplate meets with the wall surface to prevent water from seeping into the outlet box.

The following parts are available for re-order if damaged or missing.
Spare Parts List:

VAXCEL T0711 Outdoor Wall Light -fig2

VAXCEL T0711 Outdoor Wall Light -fig3

1 Year Warranty
Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.
Exclusions: This warranty does not include the failure of products from extreme acts of nature; environmental conditions not suited for the products intended use; operation in temperatures outside of the range specified in the instruction manual; usage with improper power supply, power surges or dips. For coastal locations, some corrosion is considered normal for the environment.
Vaxcel reserves the right to repair, replace or issue a credit for any properly installed product, provided it is returned per RMA instruction. This warranty is limited to the cost of the product only and does not extend to transportation, installation or replacement costs.

How can warranty service be obtained?
info@vaxcel.com
1-800-482-9235

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

VAXCEL User Manuals

Related Manuals