VAXCEL W0403-INT Galena 3 Light Vanity Instruction Manual
- October 30, 2023
- VAXCEL
Table of Contents
VAXCEL W0403-INT Galena 3 Light Vanity
Product Information
The product is a light fixture with a metal frame. It requires a maximum of 60W Type A / ST Bulb (not included). The package includes a mounting plate unit, mounting screws, wire connector, set screw, and a backplate. The fixture has a ground wire and a fixture wire. The product has a spare parts list that includes mounting hardware, mounting plate unit, mounting screw, wire connector, and set screw.
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
BEFORE INSTALLING OR SERVICING THIS FIXTURE
NOTES
- Before installing, consult local electrical codes for wiring and grounding requirements.
- READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included)
- Mounting Plate Unit (A)
- Mounting Screw (B)
- Wire Connector (C)
- Set screw (D)
Installation Steps
Turn off the power at fuse or circuit box
-
Remove the mounting plate unit (A) from the backplate by dis-assemblying the set screws (D).
-
Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B).
Note: Make sure that two set holes are lined up horizontally to make the fixture level. -
Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
-
Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
-
Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
-
Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then connect it to the house ground wire with the wire connector (C). Carefully put all of the wires back into the outlet box.
-
Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes, secure them with two set screws (D) from the side hole of the backplate into the hole of the mounting plate unit (A).
-
Install 3 x 60W max. medium base bulbs (not included). Check re-lamping label at socket area or packaging for maximum wattage allowed.
-
Attach the metal frame to the fixture by securing two assembly screws.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List
- Mounting Plate Unit (A)
- Mounting Screw (B)
- Wire Connector (C)
- Set screw (D)
- A: 11-1/2″
- B: 25-1/4″
- C: 9-1/2″
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>