xpr VKP99 Elegant Vandal Resistant Standalone Keypad User Manual
- October 30, 2023
- xpr
Table of Contents
xpr VKP99 Elegant Vandal Resistant Standalone Keypad
Product Information
The VKP99 is a security keypad system that allows users to set up master codes and user codes for access control. It features a tamper switch, dipswitch, and proximity reader for added security. The product is available in multiple languages including English, French, Italian, Spanish, German, and Dutch.
FEATURES
- Standalone vandal-resistant keypad
- Potted aluminium cast keypad with 11- core cable
- Operates on 12/24V AC/DC
- 99 User memory (codes up to 8 digits long)
- 2 outputs that operate in pulse (01 … 99 sec) or latch mode (00)
- 1 Exit button
- 30 sec lockout after 8 consecutive invalid codes
- Dipswitch to regain default settings
- Visual and audible feedback
- Tamper switch for higher security
- EEPROM prevents data loss during power failure
- Peripherals connected via bi-directional CODIX bus
- Dustproof and waterproof (IP66)
- Built-in REED switch/tamper
- Magnet holder provided
- Current Consumption Standby: 10mA, Maximum: 60mA
- Cable: 0.5 m
MOUNTING
WIRING
CONNECTING STRIKE TO THE RELAY
- NO: Normally open
- COM: Common
- NC: Normally closed
CONNECTING THE TRANSISTOR
GREEN AND RED LEDS FOR OUTPUT STATUS
Green LED indicates activation of relay output whereas Red LED indicates
activation of transistor output.
EXIT BUTTON
Exit button (NO) automatically activates relay output.
TAMPER SWITCH
REDEFINING MASTER CODE
It is possible to redefine and restore the default setting if the Master code is forgotten.
- Disconnect power and turn the Dipswitch 1 ON.
- Reconnect power. The keypad will beep continuously.
- Turn the Dipswitch 1 OFF. (Yellow LED ON + long beep).
- Press 0+00.
- Press the new MASTER Code (1 to 8 digits).
- Press A to confirm.
- Press B to exit (Yellow LED OFF).
PROGRAMMING FLOWCHART
Notes Memory Position for User
Code is always 2 digits *no need to validate with A
Assign Examples
- Ex.1 : To assign User Code “12345” at Memory Position “5” and Relay (2A) in Latch Mode assuming Master code = 000 Press 000B + 0 + 05 + 12345 + A + 3 + 05 + 1 + A + 1 + 00 + A + B.
- Ex.2: To assign User Code “6789” at Memory Position “6” and Transistor that activates for 5 seconds assuming Master code = 000 Press 000B + 0 + 06 + 6789 + A + 3 + 06 + 2 + A + 2 + 05 + A + B.
APPLICATIONS
This product herewith complies with requirements of EMC directive 2014/30/EU. In addition it complies with RoHS2 directive EN50581:2012 and RoHS3 Directive 2015/863/EU.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>