Toucan TCSC100KUAZ HD Video Conference System User Manual
- October 30, 2023
- Toucan
Table of Contents
Thank You for Purchasing VIDEO CONFERENCE SYSTEM HD
User Manual
What’s in the box
|
---|---
Conference Speaker S100A
Display Mount
Warranty Card
User Guide| Conference Camera €100
USB Cable(3m) x1
USB Cable(2m) x1
Power Adapter
Tripod Adapter
Fcc Statement
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipemnt has been tested and found to comply with the imits
for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference i residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if ot installed and used in accordance
with the instructions, may cause harmful nterference to radio communications.
However, there is no guarantee that interference will not occurin a particular
Installation. F this equipment does cause harmful nterference radio or
television reception, which can be determined by turning the ‘equipment off
and on, the user is encouraged to try to correct the interference by one of
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver s connected,
- Consult the dealer or an experienced radio/TV technici n for help.
‘This device complies with Part 15 of the FCC Rules. Operation is subject the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including intereference that may cause undesired operation.
SC10
VuPoint Solutions, Inc. (USA): 710 Nogales Street, City of Industry, CA
91748
Vupaint (Europe) Company Limited:
Innovation Center, Longbridge Technology Park, Longbridge, Birmingham B31 2TS
For additional info, vist our website at
www.toucansolution.com
© 2022 VUPOINT SOLUTIONS, INC. Al ights Reserved.
The Toucan logo and Toucan are trademarks o regisered trademarks of VuPoint
Solutions Inc. in the United States and other counties. The Bluetooth® word
mark and logos are. recstered trademarks owned by Bluetooth SG, In. Product
names, 10gos, brands and other trademarks referred to herein are the property
of thei respective trademark hoiders. Al trademarks remain the property of
their respective holders, and e used oly to describethe. products o serices
being provided. These trademark holders re not fflated with VuPaint.
Solutions,Inc. They do not sponsor or endorse VuPoint Solutions, inc’s
products o senices
Getting to know your Video Conference System HD SC100
| Volumeup
Tap toincrease volume.
---|---
**| Volume down
Tap to reduce volume
| Bluetooth
Connect with new Bluetooth device
Press and hold to enter Bluetooth pairing mode to connect with a new Bluetooth
device
Disconnect or reconnect with Bluetooth device
Tap to disconnect or reconnect with a paired Bluetooth device
| PowerOn/off
Press and hold to turn S100 on/off
**| Mute
Mute microphone
Tap to mute or unmute microphone
Voice guidance
Press and hold 10s to turn voice guidance on/off:
Getting Started
1. Turn on SC100
- Remove the top cover of S100A conference speaker and snap in C100 conference camera module.
- Plug the included power adapter into a power outlet and connect the other end to SC100
- Pressand hold on the top of the speaker for 1 second to turn SC100 on and 2 seconds to turn it off.
2.Connect SC100 to your computer
- Plug the included USB cable into your computer and connect the end with the type-C connector to SC100.
- Select S100A as the default microphone and speaker source. Select C100 as the default camera source.
3. connect 5100 with a Bluetooth Device uaoon
- Pressand hold for 2 seconds until the Bluetooth LED on 51004 begins flashing. You will hear connection guidance voice prompts.
- Enable Bluetooth on your Bluetooth device.
- Select S100A from the list of available Bluetooth devices to connect.
- You will hear a successful connection message from S100A.
- Tap to disconnect with connecting Bluetooth device.
4. Mute/Unmute
- Tap while calling to mute or unmute the microphone.
Mount C100 on Display
- Snap C100 into tripod adapter and attach it to the included display mount.
- Mount C100 on top of the display and adjust the camera view to correct position.
- Plug the included USB cable into either USB port at the bottom of $100A and connect the other end with the type-C connector to C100
- Select $100A and C100 as the default audio and videosource on your computer
http://www.toucansolution.com
For detailed product information, set up procedures and FAQ’s
please visit our website:
www.toucansolution.com or scan the QR code.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>