VEVOR Outdoor Zipline Trolley Instruction Manual

INSTRUCTION
MANUAL

(OUTDOOR USE)
Zipline Trolley

GUIDLINES FOR USE

1.  Always start from a secure and stable platform.
2. Always hold the trolley firmly with both hands (or hold on tight to the rope of the monkey swing if applicable).
3.  Release the trolley only when it has reached complete standstill, and feet can be placed onto the ground/platform.
4.  Always use the product under supervision of an adult.
5. Always check the structure, fixings, trolley, cable tensioners, cable spanner and cable before using the zip wire.
6. Do not allow children under, next to or in the neighbourhood of the construction when it is in use.
7. Do not wear loose fitting clothing (ponchos, scarfs…) when using the zip wire. This can be dangerous because of entrapment risk.
8. Do not use the zip wire when the construction and the trolley are wet.
9. Only the KBT monkey seat with special D-shackle is permitted to be attached to the trolley of the zip wire. The use of any other seats, ropes…. is considered as inappropriate use and is deemed to be dangerous.

INSPECTION AND MAINTENANCE

In order to assemble the zip wire correctly and safely, the following height requirements need to be followed. One end of the cable must be mounted at a higher level than the other end. These heights are dependant on the height of the user and the distance
between the fixing points. In order to determine the right heights, the following steps must be.
FOLLOWED:

1. Measure the height of the user. If there is more than one user, and the difference in height is less than 15 cm, use the height of the tallest user. If the difference is more than 15 cm, the zip wire needs to be adjusted every time the user’s height is outside the  specified range.
2. Add 75 cm to the measured height of the user and mark this point on the tree or construction frame.
3. Measure the distance between the 2 fixing points. Determine the corresponding height in the following table and mark this height on the tree / construction at the other side.

Height user| Height lowest fixing point (x)| Height highest fixing point according to the following distances between the 2 fixing points (y)
---|---|---
| | 24,5m| 21,5m| 18,5m| 15,5m| 12,5m
1,2m| 2m| 2,9m| 2,75m| 2,6m| 2,45m| 2,3m
1,4m| 2,1m| 3m| 2,9m| 2,75m| 2,6m| 2,45m
1,5m| 2,3m| 3,2m| 3m| 2,9m| 2,75m| 2,6m
1,7m| 2,45m| 3,35m| 3,2m| 3m| 2,9m| 2,75m
1,8m| 2,6m| 3,5m| 3,35m| 3,2m| 3m| 2,9m

TOOLS REQUIRED

HARDWARE

TOOLS REQUIRED

PRODUCT ASSEMBLY

1. Wrap the cable sling around the tree.Pass the looped ends of the cablesling through the turnbuckle.Use  M13 wrenche to fix one  end anduse  Y-type socket key  M12to  tighten theturnbuckle’s  screws.（Both ends are fixed in  the sameway）
2. Pass the main cable through the zipline trolley and spring brake.
3. Wrap the main cable around the another tree.Fix the main cable with U-clamps.Tighten the screws of the U-clamps with Y-type socket key M8.
4. Open the lock under the zip line trolley and install the swing on the lock.
5. Tighten the turnbuckle as shown in the figure to keep the main cable straight.

INSTRUCTIONS FOR USE

1. Please keep this instruction sheet safely for future reference, and ensure that you review it with all users.
2. Inappropriate use or faulty application of the product is explicitly forbidden and absolves the manufacturer of all liability.
3. The use of the item is allowed only under continuous supervision by an adult. The product is only intended for use as a zip wire between two points, for 1 user older than 8 years and with a maximum weight of up to 150 kg.
4. The zip wire should only be used after it has been properly installed according to the following guidelines.
5.  The application of the item as part of a play frame or any other construction will have to be such that it excludes all risk of entrapment.
6.  When mounting or assembling the product, attention should be given to the minimum required distance between the product and eventual obstacles: walls, fencing, … This distance should be a minimum of 2 metres.
7. In this safety area no hard, angular or pointed objects should be present. The surface underneath the product should be flat and shock absorbing. The product must not be placed on tarmac, concrete or any other hard surface. We advise the removal and storage of all accessories during winter because the characteristics of the soil (when frozen) are not suitable for safe play.
8.  Please ensure that the tree, branch or construction to which the zip wire is attached, is able to support a weight of 300 kg.

WARNING

• Adult assembly and supervision required.
• This product should be unpacked and assembled by an adult,including site and tree selection.
• In unassembled state, it contains potentially hazardous small objects,
• please keep out of children’s reach.
• Max User Weight 150kg
• User Age 3+
• Make sure overhead can support 300kg

**** WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, or neglect of this product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>