JESCO CM404RA-07R Luke LED 7 Inch White Flush Mount Ceiling Light Instruction Manual
- June 9, 2024
- JESCO
Table of Contents
JESCO CM404RA-07R Luke LED 7 Inch White Flush Mount Ceiling Light
INSTALLATION INSTRUCTIONS
LED TRIMLESS SURFACE MOUNT 7″/9″/11″
PACKAGE CONTENTS
COMPATIBLE DIMMERS
LUTRON
- PD-6WCL
- DVCL-153P
- CTCL-153P
- MACL-153M
- TGCL-153P
LEVITON
- 6681
- 6672
WARNING
FOR YOUR SAFETY READ AND UNDERSTAND INSTRUCTIONS COMPLETELY BEFORE STARTING
INSTALLATION. BEFORE WIRING TO POWER SUPPLY, TURN OFF ELECTRICITY AT THE FUSE
OR CIRCUIT BREAKER BOX.
CAUTION: RISK OF FIRE
SUPPLY CONDUCTORS (POWER WIRES) CONNECTING THE FIXTURE MUST BE RATED MINIMUM
90°C. IF UNCERTAIN, CONSULT AN ELECTRICIAN.
CAUTION: RISK OF ELECTRIC SHOCK
DISCONNECT POWER BEFORE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING.
SAFETY PRECAUTIONS
FOR SAFETY, READ AND UNDERSTAND INSTRUCTIONS COMPLETELY BEFORE STARTING
INSTALLATION. ELECTRICITY SHOULD BE TURNED OFF AT THE FUSE OR THE CIRCUIT
BREAKER BOX BEFORE INSTALLING THE FIXTURE. ALL ELECTRICAL CONNECTIONS MUST BE
IN ACCORDANCE WITH N. E. C. OR YOUR LOCAL CODE.
ASSEMBLY INSTRUCTIONS
- PREPARING FOR INSTALLATION: DISCONNECT ELECTRICAL POWER BEFORE INSTALLING OR SERVICING ANY PART OF THIS FIXTURE.
- THIS PRODUCT SHALL BE SURFACE MOUNTED WITH JUNCTION BOX OR NON-COMBUSTIBLE SURFACE ABOVE 4 FEET (1.2 METER) HIGH. USER SHOULD PREPARE NECESSARY ACCESSORIES AND SPARE PARTS (NOT PROVIDED) INCLUDING JUNCTION BOX AND SCREWS.
TOOLS REQUIRED
INSTALLATION
INSTALLATION: OPTION 1 : FLUSH MOUNT
- Step 1: Prior to installation, install mounting plate into electrical outlet box with mounting screws. Drive screws completely to the end of the junction box.
- Step 2: Connect supply wires to wires on the fixture with wire nuts, or push wires into Quick Connector. Connect white to white, black to black, and copper wire to copper wire as grounding connection.
- Step 3: Complete installation by pushing the fixture into the mounting plate
WARNING:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
INSTALLATION : OPTION 2 : RETROFIT RECESSED CAN
- Step 1: Insert wires into Quick Connector. Black to black and white to white. Attach ground wire to ground screw in recessed can.
- Step 2: Place E26 lamp holder into socket base.
- Step 3: Connect quick connectors and tuck all wires into recessed can. Squeeze springs and push up into recessed can.
- www.jescolighting.com
- [email protected]
- Tech Support: 855.592.0029