POWER-LITE ID10WCOB-CC 10W LED COB ANTI-GLARE Downlight Installation Guide
- October 30, 2023
- POWER-LITE
Table of Contents
POWER-LITE ID10WCOB-CC 10W LED COB ANTI-GLARE Downlight
Important Safety Instructions
Basic safety
precautions should always be followed when installing, including the
following:
- Read all instructions.
- Licensed electrician for installation only.
- IP54 for indoor use only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Instructions
The fitting has an insulating ceiling type IC-4 rating. Building material and
thermal insulation that can safely be exposed continuously to temperatures up
to 90℃ may abut and cover the luminaire.
If the building material cannot meet this condition, the minimum clearance of
25mm is required. See Figure 1 :
Tab 1: Ceiling cutout reference table.
Downlight dia (inch)
| 2.5| 3| 4| 6| 8
---|---|---|---|---|---
Ceiling Cutout (mm)| 70-75| 90| 120| 160|
190
NOTE: Before installation, please check the IP label on the luminaire to choose the right place to install.
P20/IP40 Indoor use only, do not use in wet or damp place.
IP44/IP54 Suitable for indoor areas including bathrooms and
covered/sheltered areas such as porches.
IP6 Suitable for outdoor areas, not suitable for water immersion.
NOTE: Before installation, please check the information of driver as below.
Non-dim Can not be used with any dimmer.
Triac dim Compliable with recommended TRIAC dimmers, dimming range
8-100%.
Installation Procedure
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
- Risk of overheating of fire if the clearance distances are compromised.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly
Downlight with internal driver
Please select the colour temperature (CW/NW/WW) before installation.
-
Cut a hole according to the cutout size of led downlight.
-
Use screw-driver to open the driver terminal cover on the back of downlight, feed the main AC wire L. N. in terminal block respectively, then fix the cover back.
-
Hold back the spring clip then push the downlight into the hole.
-
Make sure the downlight fixed tightly in ceiling, turn on the power (Fig 1).
RISK OF FIRE – Required clearance from structural members and building
elements
SCB=25mm HCB=25mm
Warning:
Input wire diameter ≥0.75mm²；
Product modification and improper installation void the warranty!
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Documents / Resources
|
POWER-LITE ID10WCOB-CC 10W LED COB ANTI-GLARE
Downlight
[pdf] Installation Guide
ID10WCOB-CC, ID10WCOB-CC 10W LED COB ANTI-GLARE Downlight, ID10WCOB-CC ANTI-
GLARE Downlight, 10W LED COB ANTI-GLARE Downlight, LED COB ANTI-GLARE
Downlight, COB ANTI-GLARE Downlight, LED ANTI-GLARE Downlight, ANTI-GLARE
Downlight, Downlight
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>