VAXCEL T0653 Chiasso 2 Light 14 Tall Outdoor Wall Sconce Instruction Manual
- October 30, 2023
- VAXCEL
Table of Contents
VAXCEL T0653 Chiasso 2 Light 14 Tall Outdoor Wall Sconce Instruction Manual
T0653
WWARNING: Turn off the main power at circuit breaker before installing
fixture.
NOTE: 1. Before installing, consult local electrical codes for wiring and
grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Installation Steps
Turn off the power at fuse or circuit box.
- Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.
- Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled fixture mounting screws if necessary. Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.
- Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows: · Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. · Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. · Attach the fixture ground wire (usually green insulation or bare wire) to the mounting plate unit (A) with the green ground screw. Then, depending on local code, connect it to the house ground wire with the wire connector (C). Carefully put all of the wires back into the outlet box.
- Attach the backplate of the fixture to the mounting plate unit (A) by inserting fixture mounting screws into set holes on the backplate, then secure it with two rubber pads (E) and two bolt nuts (D). Note: With silicone caulking compound, caulk completely around where the backplate meets with the wall surface to prevent water from seeping into the outlet box.
- Remove the cover from the fixture.
- Install the bulbs (not included). See revamping label at socket area or packaging for maximum wattage allowed.
- Attach the cover back to the top of the fixture carefully.
Turn on the power at fuse or circuit box.
Optional Installation: Disconnect Dusk-to-Dawn Photocell
IMPORTANT: Compatible with dimmer when photocell is disconnected. * Requires dimmable bulb and compatible dimmer switch.
- Turn off the power at the fuse or circuit box before starting installation.
- Loosen the wire connectors connected with the wires from photocell. (See Fig.1) Note: Do not remove the photocell to prevent water from seeping into the outlet box.
- Take a white pigtail and black pigtail and make wire connections using wire connectors (C): (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source. Put all wires back into the back plate of the fixture.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>