ZASS ZWD 16 C Hot and Cold Water Dispenser Instruction Manual
- October 30, 2023
- ZASS
Table of Contents
HOT & COLD WATER DISPENSER
INSTRUCTION MANUAL
MODEL: ZWD 16 C
PLEASE READ THIS INSTRUCTION
MANUAL THOROUGHLY BEFORE USING
Sole importer in Romania:
ZASS Romania SRL (CUI RO15328988)
Unchain nR. 40 A, cod 547605, Murres
Telephone: 0265-262870, 0265-269209, Fax: 0265-307670
www.zassromania.ro, e-mail:
office@zass.ro
INSTALLATION AND PLACEMENT
- The recommended placement of the dispenser is indoors, away from direct sunlight and excessive dampness.
- Place the dispenser on a flat and stable surface.
- Place the dispenser in a well-ventilated area. The unit should be at least 6 inches away from any wall.
- Placement of the unit should be in an area away from harmful gases and excessive heat sources.
OPERATION
-
Place the drinking water bottle after confirming the cold water baffle to be securely in place.
-
Drain water from hot water faucet after filling the dispenser with drinking water. CAUTION: Do not connect the power source until water comes out of the hot water faucet.
-
Turn red switch on, the heating indicator will light and the unit begins to heat. Turn green switch on, the cooling indicator will light and process begins. Please select whether or not you want the hot water or cold water function on. For dispenser with refrigerator, when you turn green switch on, the refrigerator begins to work as well.
-
When red light goes out automatically, the temperature of the hot water comes up to 95’C or so. If the temperature is lower than 85 ‘C, the red light will be on automatically and another process of heating begins.
-
When the green light goes out automatically, the temperature of cold water is below 10’C.
-
If the dispenser will not be used for a long period of time, completely drain the water in the hot tank by opening the hot water drainage cap located on the rear side of the
dispenser. For dispenser with refrigerator, it needs to wipe the refrigerator. -
If the wire is damaged, it must be changed by professional or the like from the maintenance department of manufacturer factory in case of any dangers.
PRECAUTIONS
- Use drinking water only.
- Keep the condenser free from dirt and dust.
- Do not tilt the dispenser more than 45 degrees or you may damage the compressor.
- The unit is equipped with a grounded plug. Do not alter or change the plug in any way.
- Never turn on heating switch when there is no water.
- Hot water is hot enough to cause injuries. Please keep your children away from the hot water faucet.
- Please turn off the power switch when stopping using it.
- For dispenser with refrigerator, please do not open the refrigerator too frequently or leave the door open. Otherwise, the water may freeze. Once water freezes, turn off the cooling switch and re-run the unit in one hour.
CLEANING AND MAINTENANCE
- Clean the main body and/or its interior with a piece of clean wet cloth.
- Do not clean it with a chemical cleanser.
- After cleaning it, completely dry it. Disconnect the power supply during cleaning to avoid danger of electric shocks.
TECHNICAL DATA
Model | ZWD 16 C |
---|---|
Power source | 220V/240V-50Hz/60Hz |
Heating power | 550W |
Cooling power | 90W |
Cold water temperature | 6-1 O’C |
Hot water temperature | 85-95’C |
Shock protect type | I |
Refrigerator temp | / |
Volume of refrigerator | / |
Refrigerant/pour | R134a/32g |
STRUCTURE
| ![ZASS ZWD 16 C Hot and Cold Water Dispenser
- STRUCTURE 2](https://manuals.plus/wp-content/uploads/2023/06/ZASS-ZWD-16-C
-Hot-and-Cold-Water-Dispenser-STRUCTURE-2.jpg)
---|---
No.| Name
---|---
1| Water guard
2| Power indicator
3| Heating indicator
4| Colonia indicator
5| Hot water faucet
6| Cold water faucet
7| Drip tray
8| Door
9| Cooling switch
10| Heating switch
11| Condenser
12| Power cord
13| Earth
14| Drainage cap
- Technical data are subject to change without notice
CIRCUIT ILLUSTRATION
1. HEATING SWITCH(RED)
2. 85° C THERMOSTAT
3. HEATER
4. HEATING INDICATOR(RED)
5. FUSE
6. 95° C THERMOSTAT| 7. COMPRESSOR
8.OVERHOT PROTECTOR
9. COOLING THERMOSTAT
10. COOLING SWITCH(GREEN)
11. COOLING INDICATOR(GREEN)
---|---
WARNING
The instructions shall state the substance of the following:
This appliance is not intended for use by people (including children) with
disabilities or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Do not make any changes or damage to the cooling system. Any changes or
maintenance to the cooling system should be done by qualified organization.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>