SCORPION Power System User Guide

SCORPION Power System

Scorpion User Guide for Jeti Telemetry

1. Connect ESC to your PC using Vlink II cable and set Communication protocol (1E) to Jeti Exbus.
   

2. Connect your Tribunus ESC to your Jeti RX
   – Connection is made with a simple male to male servo extension cable (patch cable)
   – Use your Empty port with ExBus function (E1, E2) on your duplex receiver to connect to ESC PC port.
   

3. Go to Menu - > Model -> Device Explorer -> Rex7 -> Alternative Pin Cong and set pin to ExBus (in our example OutPin7/E2 set to ExBus)
   

4. Go to Timer/Sensors - > Sensors/Logging Setup. You should see Scorpion ESC telemetry connected. If not press “Auto” button and wait for Telemetry sensors to be added to this list.
   

5. To show telemetry data on your main screen, go to Timer/Sensors - > Displayed Telemetry -> and Press “Add”
   
   Select sensor to be added to the screen and press “OK” - > then choose the size of display -> then press “Add”
   
   You can see it on your main screen
   

6. To Add alarm event for your telemetry sensors, go to Timer/Sensors - > Alarms and press “Add”
   
   Choose sensor you need
   
   Make alarm enabled
   
   And set condition for alarm
   
   Press “Ok” and you will see new alarm added.
   
   

7. If you need Telemetry voice assistant, go to the Timer/Sensors - >Voice output -> Sensors & Variables
   
   

And setup Repeat and Trigger conditions for each sensor output.

Documents / Resources

| SCORPION Power System [pdf] User Guide
Power System
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>