milleteknik 3U010000024BP01 24V Battery Panel User Guide
- June 10, 2024
- Milleteknik
Table of Contents
milleteknik 3U010000024BP01 24V Battery Panel User Guide
1. ABOUT BATTERY PANEL 24V / BATTERY PANEL 48V
Battery connection panel 24 V / 48 V for connection of four FT (front terminal) batteries.
The Battery Panel makes the connection between the power supply mounted in a 19″ rack cabinet and batteries simple and smooth. Weekly tests of batteries and alarms for aged batteries. The Battery Panel is available in configurations for 24 V – 48 V and for 125 Ah batteries up to 300 Ah batteries. Supplied with cabling for FT-batteries, (front terminal) and cabling for power supply. The power supply must be made by Milleteknik. The product is mounted in 19″ rack cabinets and is compatible with power supplies for mounting in 19″ rack cabinets, such as EN54 24V 15A 1U. It is also possible to use the Battery Panel with a power supply in the NEO, NOVA or EN54-FLX M series, but then an adapter is needed: Adapter FLX to Battery shelves.
SAFETY – RISK OF ACCESSING THE BATTERY TERMINALS
- The product must be installed in a locked and protected indoor environment. Risk of access to battery terminals
- Only authorized persons should install and maintain the system.
- It is the installer’s responsibility that the system is suitable for intended use.
- Documents accompanying the system must be stored in it or in its immediate vicinity.
- Mains voltage should be disconnected during installation.
1.1. Installation in 19″ rack
The unit must be mounted in a 19″ rack. Bracket is screwed into rack with M6 screw and basket nut, at least one on each side. Use the appropriate screw and nut for the rack. Screw and nut not included.
1.2. Overview and connecting batteries
- Connect batteries – risk of short circuit, connect the poles correctly. Red = + and black = -.
- Connect power supply.
- Turn on battery fuse.
- Set power supply in operating mode.
1.3. Technical data
Manual article number: 350-077 . Product data sheet no: N/A. This translation
is not verified and should be cross referenced with the swedish original
before use.
This document is subject to change without notice.
All information is published subject to typographical errors.
This translation is not verified and should be cross referenced with the
swedish original before use.
1.4. Address and contact details
Milleteknik AB
Ögärdesvägen 8 B
S-433 30 Partille
+46 31 340 02 30
www.milleteknik.se
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>