SDHQ 52-1142-200-A Switch Pros Power Module Mount Instruction Manual
- June 10, 2024
- SDHQ
Table of Contents
Product Packing List
Product: SDHQ-52-1142-200
Description: 2008-21 Toyota Land Cruiser and Lexus LX
570 Switch Pros Power Module Mount
(1) SDHQ Power Module Mount SDHQ-52-1142-200-A
(1) Hardware Package SDHQ-52-1142-200-B
(2) M8 – 1.25 x 30mm S.S. Button Head Bolts
(2) M8 S.S. Washers (2) M8 S.S. Split Lock Washers
INSTALLATION INSTRUCTIONS
Product: SDHQ-52-1142-200
Description: 2008-21 Toyota Land Cruiser and Lexus LX 570 Switch Pros Power
Module Mount
Parts List
(1) SDHQ Power Module Mount SDHQ-52-1141-200-A
(1) Hardware Package SDHQ-52-1141-200-B
Hardware List
(2) M8-1.25x30mm S.S. Button Head Bolts
(2) M8 S.S. Washers
(2) M8 S.S. Lock Washers
Required Tools
10mm Socket and Ratchet
1/8” Hex Bit
3/32” Hex Bit
Open Barrel Crimping Tool Wire Strippers
3/8” Deep Socket
Tech Notes
Use anti-seize on stainless steel hardware.
Also fits RedArc 30 Amp Solar Regulator. Does not include mounting hardware
for regulator.
Approx install time = 30 Minutes (not including wiring)
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING
INSTALLATION!
Installation Instructions:
- Pre-Install. Place the Switch Pro Panel on top of the Mounting Plate. Use Switch Pros provided hardware to mount Switch Pros Power Module to mount and torque to 18 in-lbs.
- In the engine bay, locate two threaded holes on the driver side of the bay by the firewall. Thread in the (2) M8 bolts, washers and lock washers into the holes and leave space for the mount to slide between the washers and fender.
- Slide the assembled mount and Switch Pros Power Module onto the bolts and tighten. Then finish wiring and enjoy your SDHQ Switch Pros Power Module Mount!
Wiring:
Once the Switch-Pros power module is mounted, but BEFORE it is connected to anything else, do the following:
- Reinstall battery (if battery was removed during installation), and secure factory connections. Start vehicle and confirm that battery is properly installed, connected and grounded.
- Connect the Switch-Pros Ground wire lug to the negative terminal on the battery (grounding elsewhere will not properly filter noise and will void your product warranty).
- Plug the 16-pin harness into the power module; be sure it locks in.
- Connect the red Battery Cable to the positive terminal on the battery. Tighten down both ends, to prevent lug from rotating and possibly causing friction or spark
Double check all hardware is installed correctly and tight
Re-torque ALL bolts after 100 miles
190 S McQueen Rd
Ste 109 Gilbert, AZ 85233
www.sdhqoffroad.com
Follow us on:
Facebook
Instagram
For questions or help with the installation, please email
help@sdhqoffroad.com
Store front hours: Mon. – Fri. 8:00am – 5:30pm and Sat. 9:00am – 2:00pm
Arizona Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>