SDHQ 2019+ RAM 1500 Pillar Light Mounts Installation Guide
- June 3, 2024
- SDHQ
Table of Contents
SDHQ 2019+ RAM 1500 Pillar Light Mounts
INSTALLATION INSTRUCTIONS
Product: SDHQ-33-1206-G5
Description: 2019+ Ram 1500 A-Pillar Light Mounts
Parts List
| Hardware List|
Required Tools
---|---|---
(1) Driver Side Mount SDHQ -33-1206-G5-A
(1) Passenger Side Mount SDHQ -33-1206-G5-B| N/A| 13mm Socket
Ratchet Hood Prop Marker
Tech Notes
No drilling or cutting required.
Use a hood prop and mark the outline of hood hinges to assist in realignment
during install.
NOTE: Windshield wipers CANNOT be operated with Hood open.
Approx. Install Time: 1 Hour (not including wiring)
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION!
Installation Instructions
-
While not necessary, it is recommended that masking tape is applied to the edge of the hood, windshield, and fender where you will be working to prevent accidental paint damage.
-
Open the hood and support it with a hood prop. Mark the hood and hinge in such a way will assist in aligning the hood later. Then, starting on the driver’s side with the 13mm socket and ratchet, remove the rear nut that attaches the hood to the hinge. Next, loosen the front nut while supporting the hood to prevent it from sliding down the hinge.
-
Locate the driver side A-Pillar light mount and slide it under the hood from the windshield. The A-Pillar will go between the windshield fluid line and the hood. Slide the front slot in between the hood hinge and factory nut. Align the rear slot to the rear bolt.
Tighten enough to support the mount. -
Align the mount all the way forward and towards the outside of the vehicle. Use the outline of the paint on the hood and your alignment marks to align it back into factory position. Tighten both nuts once the hood is aligned.
-
Repeat Steps 2-4 for the passenger side A-Pillar light mount.
-
Install lights in the top slot. Position the lights as desired and wire.
Enjoy your new SDHQ A-Pillar Light Mounts!
Double check all hardware is installed correctly and tight
Re-torque ALL bolts after 100 miles
90 S McQueen Rd
Ste 109 Gilbert, AZ 85233
Phone:480-633-2929 | Fax:
480-633-1791
www.sdhqoffroad.com
Follow us on:
Facebook Instagram
For questions or help with the installation, please call SDHQ Offroad @ 480
633-2929
Mon.–Fri. 8:00am–5:30pm and Sat. 8:00am–3:30pm Arizona
Time.www.sdhqoffroad.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>