Legrand 752188 Valena Life Connected Switch Installation Guide

: June 10, 2024
: Legrand

Table of Contents

Installation
Pack Contents
Characteristics
Safety Instructions
Before Starting Wiring Precautions
Necessary Safety Precautions
Install The Connected 2 Gang Switch
SIMPLIFIED EU DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Legrand 752188 Valena Life Connected Switch

Installation

Requires you to buy and install the Valena Life with Netatmo connected starter pack first.

Control Module

OR
Gateway Power Outlet and Home/Away wireless control

Pack Contents

2 gang connected switch with neutral

Site protection

Cover plate

Characteristics

This switch works with the following loads

Transformers should be charged to over 60% of their rated power.
Take account transformer losses for power calculations.

Safety Instructions

This product should be installed in compliance with installation rules, preferably by a qualified electrician. Incorrect installation and/or incorrect use can lead to risk of electric shock or fire. Before carrying out the installation, read the instructions and take account of the product’s specific mounting location. Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Legrand products must be opened and repaired exclusively by personnel trained and approved by Legrand. Any unauthorised opening or repair completely cancels all liabilities and the rights to replacement and guarantees. Use only Legrand brand accessories.

Before Starting Wiring Precautions

If you plan to install two-way light switches, read the following precautions:
To control 1 light with 2 or more points of control, use only the following products :

Wireless lighting controls (not included in this pack).
Up to 20 maximum

Do not use: two 2gang connected switches to control the same lighting point.

Necessary Safety Precautions

Switch off the power at the main circuit breaker
Make sure that the power is off before continuing with the installation.

Install The Connected 2 Gang Switch

Remove the existing switch

Wire the connected 2G switch

Tip if replacing an existing 2-way switch

The travellers 1 and 2 of the old switch must be wired together in terminal 1 or 2 of the new connected switch.

Old flush mounted switch replaced by a wireless lighting control

Use a connector to connect all 3 wires together (travellers 1 and 2 and lamp return wire). Use a separate connector to insulate the neutral wire.

To add a connected product to your connected installation, you should follow the instructions :

– in the Legrand Home + Control application (Settings/Add a new product section)
– or consult the user manual on legrand.fr

www.legrand.fr

SIMPLIFIED EU DECLARATION OF CONFORMITY

The undersigned,
Legrand
declares that the radio-electric equipment referred to in these instructions complies with directive 2014/53/EU.
The full text of the EU declaration of conformity is available on the following website :
www.legrandoc.com