Joie Trillo Shielded Booster Car Seat Instruction Manual

JoieTrillo Shielded Booster Car Seat

Trillo Shield High Back Booster

Congratulations on your purchase of the Joie Trillo Shield High Back Booster! This product is a Group 1/2/3 booster and is suitable for children weighing 9-36kg (approximately 1-12 years old). It is a high-quality booster that is fully certified for safety. Please read the following instructions carefully to ensure a comfortable ride and best protection for your child.

Product Information

• Head Support
• Lower Back Support
• Pillow Cushion
• Armrest
• Base
• Adjustment Button
• Cupholders
• Head Support Adjustment Lever
• Shoulder Belt Guide
• Side Impact Shield
• Latch Connector

Please make sure all parts are available before assembly. If any part is missing, please contact your local retailer. No tools are required for assembly.

Usage Instructions

This booster can be installed using a 3 point retractable adult seat belt approved to ECE Regulation No. 16 or other equivalent standards. Please ensure the following:

• Install the booster so that it is not liable to become trapped by a movable seat or in a door of the vehicle.
• This booster is designed ONLY for children weighing 9-36kg (approximately 1-12 years old or under).
• Failure to properly use this booster increases the risk of serious injury or death in a sharp turn, sudden stop or crash.
• DO NOT use another manufacturer’s soft goods with this booster. See your retailer for Joie replacement parts only.
• DO NOT use in any configuration not shown in the instructions.
• Children are safer when properly restrained in rear vehicle seating positions, rather than front seating positions. For a vehicle with a front passenger airbag, refer to your vehicle owner’s manual as well as these instructions for a booster installation.
• NEVER leave your child unattended.
• After your child is placed in this child restraint, the safety belt must be used correctly, and ensure that any lap strap is worn low down, so that the pelvis is firmly engaged.
• NEVER leave a booster unsecured in your vehicle. An unsecured booster can be thrown around and may injure occupants in a sharp turn, sudden stop or crash. Remove it or make sure that it is securely belted in the vehicle.
• NEVER leave luggage or other objects unsecured in a vehicle, they are liable to cause injuries in the event of a collision.
• Replace the booster after an accident of any kind. An accident can cause damage to the booster that you cannot see.
• DO NOT modify your booster or use any accessories or parts supplied by other manufacturers.
• NEVER use a booster if it has damaged or missing parts. DO NOT use a cut, frayed or damaged vehicle seat belt.
• The booster can become very hot if left in the sun. Contact with these parts can burn your child’s skin. Always touch the surface of any metal or plastic parts before putting your child in the booster. Thank you for choosing Joie Trillo Shield High Back Booster! If you have any further questions or concerns, please do not hesitate to contact us.

Welcome to Joie™

Congratulations on becoming part of the Joie family! We are so excited to be part of your journey with your little one. While traveling with Joie trilloTM shield high back booster you are using a high quality, fully certified safety Group 1/2/3 booster. This product is suitable for use with children weighing 9-36kg (approximately 1-12 years old). Please carefully read this manual and follow each step to ensure a comfortable ride and best protection for your child.

Please confirm
This booster can be installed using a 3 point retractable adult seat belt approved to ECE Regulation No. 16 or other equivalent standards.

Booster

IMPORTANT: KEEP FOR FUTURE REFERENCE. PLEASE READ CAREFULLY.
Please keep the instruction manual in the storage compartment at the bottom of the booster as right figure.

Parts List

Make sure all parts are available before assembly. If any part is missing, please contact local retailer. No tools are required for assembly.

1. Head Support
2. Lower Back Support
3. Pillow Cushion
4. Armrest
5. Base
6. Adjustment Button
7. Cupholders
8. Head Support Adjustment Lever
9. Shoulder Belt Guide
10. Side Impact shield
11. Latch Connector

WARNING

• Do take care to locate and install the booster so that it is not liable to become trapped by a moveable seat or in a door of the vehicle.
• This booster is designed ONLY for child weighing 9- 36kg (approximately 1-12 years old or under).
• Failure to properly use this booster increases the risk of serious injury or death in a sharp turn, sudden stop or crash.
• DO NOT use another manufacturers soft goods with this booster. See your retailer for Joie replace-ment parts only.
• DO NOT use in any configuration not shown in the instructions.
• According to accident statistics, Children are safer when properly restrained in rear vehicle seating positions, rather than front seating positions. For a vehicle with a front passenger air bag, refer to your vehicle owner’s manual as well as these instruc-tions for a booster installation.
• NEVER leave your child unattended.
• After your child is placed in this child restraint, the safety belt must be used correctly, and ensure that any lap strap is worn low down, so that the pelvis is firmly engaged.
• NEVER leave a booster unsecured in your vehicle. An unsecured booster can be thrown around and may injure occupants in a sharp turn, sudden stop or crash. Remove it or make sure that it is securely belted in the vehicle.
• NEVER leave luggage or other objects unsecured in a vehicle, they are liable to cause injuries in the event of a collision.
• Replace the booster after an accident of any kind. An accident can cause damage to the booster that you cannot see.
• DO NOT modify your booster or use any accessories or parts supplied by other manufacturers.
• NEVER use a booster if it has damaged or missing parts. DO NOT use a cut, frayed or damaged vehicle seat belt.
• The booster can become very hot if left in the sun. Contact with these parts can burn your child’s skin. Always touch the surface of any metal or plastic parts before putting your child in the booster.
• NEVER give this booster to someone else without also giving them this manual.
• NEVER use a second-hand booster or a booster whose history you do not know.
• DO NOT use this booster without the soft goods.
• The soft goods should not be replaced with any besides the ones recommended by the manufac-turer, because the soft goods constitute an inte-gral part of the booster performance.
• DO NOT use any load-bearing contact points other than those described in the instructions and marked on the booster.
• DO NOT face your booster toward the rear of the vehicle.
• To avoid burns, never put hot liquids in your cupholders.

Emergency
In case of emergency or accidents, it is most important to have your child taken care of with first aid and medical treatment immediately.

Product Information

Read all the instructions in this manual before using this product. If in doubt, consult either the booster manufacturer or the retailer.

1. This booster is a ‘Universal’ child restraint. It is approved to UN ECE regulation 44, 04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a ‘Universal’ child restraint for this age group.
3. This booster has been classified as ‘Universal’ under more stringent conditions than those which applied to earlier designs which do not carry this notice.

For Installation with Latch System and 3-point-belt

1. This booster is a ‘Semi-Universal’ child restraint. It
   is approved to UN ECE regulation 44, 04 series of amendments for general use in vehicles fitted with ISOFIX anchorages systems.

2. It will fit vehicles with positions approved as ISOFIX positions (as detailed in the vehicle handbook), depending on the category of the booster and of the fixture.

3. If in doubt, consult either the booster manufacturer or vehicle manufacturer.

Product Booster
Suitable for Child weighing 9-36kg
Mass Group Group 1/2/3
Materials Plastics, metal, fabrics
Patent No. Patents pending

Booster Assembly

Assemble Side Impact shield
see images 1 – 2
Align the side impact shield with the slot of lower back support plastics mounts, and then insert to lock. 1 2

Assemble Pillow Cushion
see images 3
The completely assembled booster is shown as 4

Height Adjustment

for Head Support

see images 5

Concerns on Installation

see images 6 – 9

Installation with 3-point-belt

see images 10 – 21
If vehicle is equipped with ISOFIX, the vehicle lower anchor points may be visible at the vehicle seat crease. See your vehicle owner’s manual for exact locations, anchor identification, and requirements for use.

1. Place the booster in forward- facing position on a forward- facing vehicle seat with anchors, hook latch connectors to vehicle anchors. 10
   NEVER put two latch connectors on one vehicle ISOFIX anchor unless specifically allowed by the vehicle manufacturer.

2. Secure the booster firmly by pushing it downward with knee or hand while pulling the adjustment belt. 11

3. For ease of unhooking, extend the adjustment belt to its maximum length by pressing the adjustment button. 12
   ! The latch connectors are tucked in at the bottom of the booster. Make sure to detach them before connecting the booster to the vehicle seat. 13

4. Please make sure that the backrest of the child safety seat rests flat against the backrest of the car seat so that the child seat is under no circumstances in a reclined position. 15

Use Pillow Cushion
(Forward Facing Mode/ for Child between 9-18kg / 1–4 years old) see images 16

• Pull the vehicle safety belt and pass through the belt path 16 , and then buckle it up. 16 -1
• The booster can not be used if the vehicle safety belt buckle (female buckle end) is too long to anchor the booster securely. 16 -2
• To ensure the correct head support height is obtained, the bottom of the headrest MUST be even with the top of child’s shoulders as shown in 16 -3
• Make sure that both lap belt and diagonal belt are always tightly fastened.
• When the pillow cushion is not used, please store it properly.
• Belt must not be twisted.

For Use Without Pillow Cushion

(Forward Facing Mode/ for Child between 15-36kg / 3–12 years old)

see images 17 – 21

Pull the vehicle safety belt and pass through the belt path 17 , and then buckle it up. 17 -3

• Position shoulder belt through the shoulder belt guide shown in 17 -1
• DO NOT position vehicle belt over top of the armrests. It must pass underneath the armrests. 17 -2
• The booster cannot be used if the vehicle safety belt buckle (female buckle end) is too long to anchor the booster securely. 17 -4
• The lap belt must be low down on hips. The booster is shown as 17
• To ensure the correct head support height is obtained, the bottom of the headrest MUST be even with the top of child’s shoulders as shown in 18 and the shoulder belt must be positioned in the red zone as shown in 19 .
• Place a booster firmly against the back of a forward-facing vehicle seat equipped with a lap/shoulder belt.
• Have your child sit in a booster seat with their back flat against back of a booster.
• NOT as shown in 21 . Fasten buckle and pull up on the shoulder belt to tighten.20
• If the belt lays across child neck, head or face, readjust head support height.
•  Belt must not be twisted.

Use Cupholders

see images 22

Detach Soft Goods

see images 23 – 24
Detach 2 pairs of buttons and 6 pairs of elastics at the rear of the booster. 23

Detach buttons as 23 -1 To refit the seat pad simply reverse the steps above.

Care and Maintenance

• Please wash the soft goods and inner padding with cold water under 30°C.
• Do not iron the soft goods.
• Do not bleach or dry clean the soft goods.
• Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the booster. It may cause damage to the booster.
• Do not twist the soft goods and inner padding to dry with great force. It may leave the soft goods and inner padding with wrinkles.
• Please hang dry the soft goods and inner padding in the shade.
• Please remove the booster from the vehicle seat if not in use for a long period of time. Put the booster in a cool, dry place and somewhere your child cannot access it.

References

• Baby Gear That Goes Above & Beyond | Joie

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>