Steinbach 049085 Solar Shower Owner’s Manual
- June 10, 2024
- Steinbach
Table of Contents
049085 Solar Shower
Owner’s Manual
049085 Solar Shower
Package contents/components
-
O-ring for shower head Ø 19 x 3 mm
-
Connecting element
-
Tank top part
-
O-ring for tank Ø 29 x 5 mm
-
Faucet
-
Tank bottom part
-
Drain cap
-
Hose adapter
-
Cold water outlet
-
O-ring for cold water outlet Ø 19 x 4 mm
-
Shower head
-
Allen wrench Operating instructions (no illustration)
Required tools/materials (not supplied) -
Attachment material (screws and wall anchors for your stone, concrete or wooden floor) or the Steinbach outdoor floor element Optionally available
-
Steinbach outdoor floor element including attachment material (item no. 049028)
General Information
Read and keep the operating instructions
These operating instructions are a part of this solar shower (also referred to
hereinafter as the “product”). They contain important information about start-
up and operation.
Read the operating instructions and especially the safety instructions
carefully before using the product. Non-observance of this operating
instructions manual may lead to severe injuries or damage to the product.
Keep the operating instructions for further use. If you pass on the product to
a third party, you must pass on operating instructions as well.
Intended use
This product is exclusively designed for outdoor showering.
This product is exclusively intended for private use and not suited for the
commercial sector.
Only use the product as described in these operating instructions. Any other
use is considered inappropriate and may lead to material damage or even
injury. The product is not a toy.
The manufacturer or retailer will not assume any liability for damage caused
by inappropriate or incorrect use.
Only use the product when it is firmly bolted down at a suitable location.
If the outdoor temperature drops below 50 °F (10 °C), the tank must be drained
and the shower must be dismantled and stored in a dry, frost-free place.
Foreseeable misuse
Never use the product as a climbing frame or as a post for suspending washing
lines or hammocks.
Explanation of Symbols
The following symbols are used in this operating instructions, on the product
or on the packaging.
**** | Here you will find useful additional information. |
---|---|
Not drinking water! | |
Caution! Hot water. | |
Only tighten by hand, not with tools. | |
Risk of damage! Do not open the packaging with sharp or pointed objects, |
such as cutters.
| The product is not frost-proof and must be disassembled if temperatures drop
to below 10°C.
Safety
The following signal words are used in these operating instructions.
**WARNING!
This signal symbol/word denotes a hazard with an average risk level that could
lead to death or severe injury if it is not avoided.
CAUTION!
This signal symbol/word denotes a hazard with a low risk level that could lead
to mild or moderate injury if it is not avoided.
NOTICE!** This signal word provides a warning about potential material
damage.
General safety instructions
Safety instructions for persons
**WARNING!**
Packaging materials pose a risk of suffocation!
Catching your head in the packaging foil or swallowing other packaging
materials can cause death. There is a higher risk for children and mentally
challenged persons who cannot estimate the hazard potential due to lack of
knowledge and experience.
- Prevent children and mentally challenged persons from playing with the packaging materials.
CAUTION!
Risk of scalding!
In direct sunshine, the tank heats up and the water that comes out of the
shower head can be very hot, depending on the faucet settings.
- Before showering, set the faucet between cold and hot.
- Check the water temperature before you stand under the shower head.
- Never leave children and persons with reduced physical, sensory or mental abilities (e.g. persons under the influence of alcohol) unattended in the vicinity of the product.
CAUTION!
Risk of infection!
Bacteria can multiply in the tank if the product is not used for longer
periods.
- Drain the product before and after longer periods of non-use.
- Do not drink the water from the product.
NOTICE!
- Only use spare parts and accessories supplied or recommended by the manufacturer.
- Do not open the product. Leave repairs to a qualified service technician. Contact the service address on the back of the instruction manual for this purpose. All liability and warranty claims will be void when you carry out repairs yourself, the product is improperly connection or operated incorrectly
Description
The tank 6 of the solar shower is filled with water via the connected garden
hose. This water is heated by sunlight because the matt black surface of the
tank reflects very little solar energy.
The solar shower has a cold water supply line leading directly to the faucet 5
so that the water can be adjusted to the perfect temperature for showering.
The cold water outlet 9 can be used on its own, e.g. for filling a watering
can or washing your feet.
The illustration shows how a solar shower works:
The entire shower body is filled with water and works in a similar way to an
electric water heater in which the heated water also collects at the top. If
hot water is needed, the faucet 5 at the base of the tank 6 is turned to let
in cold water and the water in the top region, which has already been heated,
is pushed out of the tank.
Any pressure that builds up due to the water heating up in the tank can
therefore escape through the shower head 11 . This causes water to drip from
the shower head when the faucet is closed.
Preparation
Preparing the setup location and the connections
The shower must be anchored to the ground so that it can be used safely.
The safest place to use the shower is on a smooth, level concrete or wooden
floor.
Careful selection and good preparation of the setup location makes it much
easier to set up and use the shower. The following requirements must be met or
considered:
- Water supply/drain, attachment and solar radiation
- Sturdy, level, waterproof and slip-proof floor, alternatively the floor element (item no. 049028)
**CAUTION!**
Risk of injury!
The product can topple.
- A second person who holds the product is required for installation.
To prepare the setup location, proceed as follows:
- The second person positions the shower at the desired location and secures it so that it cannot topple over. Mark the drilling points through the holes in the base of the shower.
- Detach the shower from the base.
- Drill suitable holes for the selected attachment materials into the floor with an electric drill.
- Put the attachment material (e.g. wall anchors) into the holes. The setup location is prepared.
Installation
Assembling the solar shower
NOTICE!
- Tighten the individual parts by hand without using any tools to prevent the risk of damage during assembly.
The screw connections are self-sealing even before parts are screwed in so
that you can align the individual parts properly. The openings of all water
outlets (such as the shower head or cold water tap) should point downwards. If
screw connections are not completely water-tight, wrap the thread in Teflon
tape.
To assemble the solar shower, proceed as follows:
- Place the O-ring for the shower head 1 on the connecting element 2 and screw the connecting element into the tank 3 using the Allen wrench 12 .
- Assemble the shower head 11 .
- Screw the shower head 11 onto the connecting element 2 .
- Place the O-ring for the tank 4 into the screw connection of the bottom part of the tank 6 .
- Position the top part of the tank 3 and screw the top part onto the bottom part.
- Screw the hose adapter 8 onto the hose connection and the drain cap 7 into the tank 6 .
- Place the O-ring 10 on the cold water outlet 9 and screw the cold water outlet into the tank. The solar shower is assembled.
Setting up the solar shower
Position the solar shower at the prepared setup location. Make sure that the
solar shower is pointing in the correct direction.
The second person supports the shower while you screw the base of the shower
into the floor with the correct attachment materials.
Filling the tank
To fill the tank 6 of your solar shower, proceed as follows:
- Connect a garden hose to the hose adapter 8 and the faucet of the water pipe. Position the garden hose so that no one can trip over it.
- Turn on the water supply faucet. Turn the faucet 5 all the way to the “hot” position and open it. In this position, the tank fills fastest. Water flows into the tank. It takes approx. 3 minutes for the tank to fill.
- As soon as water runs consistently out of the shower head 11 , close the shower faucet.
- Turn off the faucet of the water pipe. The tank is filled.
Operation
Using the solar shower
Observe the following before using your solar shower:
- Bacteria can multiply in warm water if the product is not used for longer periods. Risk of infection! The tank must be drained.
- The water temperature in the tank depends on the level of sunshine. In cloudy weather, the water will take longer to heat up. The water can become very hot in the case of intense sunlight.
- Remove obstacles from the showering area.
To use your filled solar shower, proceed as follows:
- Connect a garden hose to the hose adapter 8 and the faucet of the water pipe. Position the garden hose so that no one can trip over it. Turn on the water supply faucet.
- Turn the faucet 5 to the center position (between hot and cold). Open the shower faucet.
- Turn the faucet left or right to set your desired water temperature. Use the faucet to control the water temperature and quantity, and enjoy showering in warm water.
- After showering, close the shower faucet. Turn off the faucet of the water pipe. The shower is finished.
**** Sometimes a little water runs out of the shower head, even if the faucet is shut. This is due to the heating of warm water in the depressurized tank and is not a defect.
Cleaning
Only clean the product with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive cleaning agents can damage the product. Dry the product with a lint-free cloth.
Disassembly
Draining the tank
Disconnect the solar shower from the water pipe. Open the faucet and unscrew
the drain cap to drain the water from the tank.
Dismantling the product
Unscrew the top part of the tank from the bottom part of the tank. Remove the
attachment screws from the base of the product while the second person
supports the product. Drain the remaining water from the tank and screw the
drain cap into the tank.
Storage
After thorough cleaning and drying, store the product in a dry and frost-free
place (= +5 °C).
Troubleshooting
Fault description | Cause | Remedy |
---|
Water is still coming out of the shower head even after the faucet has been
closed.| This is caused by the water heating up in the unpressurized tank.| It
is not a defect!
Water is leaking from a screw connection.| The screw connection is not water-
tight.| Wrap the thread in Teflon tape.
There is no water coming out of the shower head.| No water is being supplied.|
Check the water supply and the garden hose for damage and blockages.
The water coming out of the shower head is not hot.| The water temperature in
the tank is too low.| Position the solar shower base in an area with plenty of
sunlight.
The water has a bad smell or is discolored.| The filled solar shower has not
been used for some time.| Drain the tank via the drain cap and refill it.
If the problem cannot be solved, contact the customer service listed on the last page.
Technical data
Model: | 49085 |
---|---|
Maximum operating water pressure: | 5 bar, use a pressure regulator if required |
Tank volume: | 35 l |
Spare parts
- 040981 – O-ring for shower head
- 040989 – Connecting element
- 040988 – Shower head
- 040986 – Hose adapter
- 049932 – Drain cap
- 040991 – Inlet valve
- 050031- Cold water outlet
- 040983 – Handle for single-lever mixer
- 049966 – Mixer faucet cartridge
Disposal
Disposing of the packaging
Sort the packaging before you dispose of it. Dispose of paperboard and
cardboard with the recycled paper service and wrappings with the appropriate
collection service.
Disposal of the product
Dispose of the product in line with the guidelines and regulations valid in
your country.
© 2022 Steinbach International GmbH
Steinbach International GmbH.
Steinbach International GmbH
L. Steinbach Platz 1,
AT-4311 Schwertberg
Spare parts
steinbach-group.com/de/ersatzteile
References
- Steinbach Helpdesk
- Steinbach Pools und Poolzubehör - “we are pool”
- Pool Ersatzteile und Zubehör bequem online bestellen | Steinbach
- Steinbach Helpdesk
- Steinbach Pools und Poolzubehör - “we are pool”
- Pool Ersatzteile und Zubehör bequem online bestellen | Steinbach
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>