ALTA WINDOW FASHIONS HONEYCOMB SHADES Stationary Fan Style Arch Instruction Manual
- June 4, 2024
- ALTA WINDOW FASHIONS
Table of Contents
ALTA WINDOW FASHIONS HONEYCOMB SHADES Stationary Fan Style Arch
INSTALLATION INSTRUCTIONS
Install the Brackets — Fan Style Arch
Mount end brackets 3” from each side and space any remaining brackets evenly. Make sure that all brackets are aligned and level. For the best fit on a non- perfect half circle in a deeply recessed window opening, position the brackets so that the arch is installed close to the original depth that the template was made.
Install the Brackets — Quarter Round
Mount the brackets to the vertical and horizontal mounting surfaces. Place brackets approximately 3” from the bottom and the top along the vertical mounting surface. Then, place a bracket approximately 3” in from both edges of the horizontal mounting surface.
Shade Assembly — Fan Style Arch Only
NOTE: Not perfect half circles have a straight edge on one end of the fabric and the other has a trimmed (jagged) edge. Orient the fabric so that the trimmed (jagged) edge, when fanned out, will become the outside edge of the arch. The straight side of the fabric stack will form the inner circle of the arch. First, remove the end caps from the rail. Then, fan the fabric out and slide the free stiffened cell of the fabric into the rail so that the ends of fabric match up with the ends of the bottom rail. Inside the center of the rail, mark where the stiffened fabric ends. For perfect half circles only, cut the plastic stiffener provided to fit the pivot opening. Then, peel the paper liner off the stiffener and adhere it to the bottom rail in the inner circle of the arch. Finally, install the endcaps back into place; the four circular dimples on the end caps should face down.
Arch Support Clip Installation
Position the clips so that the back of the clips are the same depth as the back of the installation brackets. First, place a clip at the top center of the window opening and then, space remaining clips evenly apart. Screw the arch support clips to the mounting surface through the hole in the top of the clip (IB) or through the slot in the back (OB).
Shade Installation
Shade Removal — Only if necessary
Place Fabric Into Clips
First, find the center of the fabric. Gently press on the fabric until you are able to get the back cell into the top center support clip. Then, go to the first clip up from the bottom of the arch and gently lift and fan out the fabric until the first section fits the window opening. Gently press on the fabric until you are able to get the back cell into the support clip. Repeat for remaining clips. Check the fit of the arch shade. Reposition the fabric in the clips, if necessary.
Child Safety
WARNING STRANGULATION HAZARD.
Young chidren can be strangled by cords. Immediately remove this product if a
cord longer than 22 cm or a loop Rev 7/21 Print 7/21 exceeding 44 cm around
becomes accessible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>