Harman Kardon Citation Sub Wireless Thundering Bass User Manual

Citation Sub Wireless Thundering Bass
User Manual

PRODUCT TOUR

GET STARTED

OWNER’S MANUAL
Download the full Owner’s Manual from harmankardon.com

SPECIFICATIONS

• Model Name: CITATION SUB
• Frequency response: 35~125Hz
• Signal-to-noise ratio: >80dB
• Output power: 200W RMS
• Power Supply: 100-240V ~ 50/60Hz
• Power consumption in sleep mode: <2.0Watts
• 5G WISA transmitter power: <14dBm
• 5G WISA modulation: OFDM, BPSK, QPSK, 16QAM
• 5G WISA transmitter frequency range: 5.15GHz – 5.35GHz, 5.47~5.725 GHz,5.725~5.825GHz
• Dimensions (W x H x D): 448 x 340 x 367mm (18” x 13” x 14”)
• Weight: 14.35 kg (32 lb)
• Packaging Dimensions (W x H x D): 530 x 386 x 427mm (20.9” x 15.2” x16.8”)
• Packaging Weight (Gross): 16.75 kg (36.93 lb)

Note: This product is designed to be instantly on and ready to receive signal from WiSA Tx Unit at a moment’s notice, wireless connection must remain active at all times to ensure proper operation.
The product is in compliance with the European Union energy legislation. The product will enter into sleep mode (networked standby) after 15 minutes without operation, after which it can be re-activated via wireless.
This product contains open source software. For your convenience, the source code and relevant build instruction for software licensed under the GPL is available at http://www.harmankardon.com/opensource. You may also obtain this information by contacting us at OpenSourceSupport@Harman.com
This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation. CAN

ICES-3 (B) / NMB-3 (B).
IC Caution:
User should also be advised that:
(i) the device for operation in the band 5150 – 5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250 – 5350 MHz and 5470 – 5725 MHz shall comply with the e.i.r.p. limit: and
(iii) the maximum antenna gain permitted for devices in the band 5725 – 5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250 – 5350 MHz and 5650 – 5850 MHz and that these radars could cause interference and/or damage to LE- LAN devices.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device. No configuration controls are provided for this wireless equipment allowing any change in the frequency of operations outside the FCC grant of authorization for US operation according to Part 15.407 of the FCC rules.
FCC/IC Radiation Exposure Statement: This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Use Restriction: This device is restricted to indoor use when operating in the 5150 to 5350 MHz frequency range in following countries:

| BE| EL| LI| P 1
---|---|---|---|---
BC| ES| LU| RO
CZ| FR| m| SI
DK| HR| i i1| SK
DE| IT| | H
EE| CY| A| SE
IF| LV| PL| UK(NI)
| UK
---|---

Belgium (BE), Greece (EL), Lithuania (LT), Portugal (PT), Bulgaria (BG), Spain (ES), Luxembourg (LU), Romania (RO), Czech Republic (CZ), France (FR), Hungary (HU), Slovenia (SI), Denmark (DK), Croatia (HR), Malta (MT), Slovakia (SK), Germany (DE), Italy (IT), Netherlands (NL), Finland (FI), Estonia (EE), Cyprus (CY), Austria (AT), Sweden (SE), Ireland (IE), Latvia (LV), Poland (PL) and Northern Ireland (UK).

This product contains open source software. For your convenience, the source code and relevant build instruction for software licensed under the GPL is available at http://www.harmankardon.com/opensource. You may also obtain this information by contacting us at OpenSourceSupport@Harman.com

References

• German market leader for CRM in SMEs - CAS Software
• Harman Kardon
• Anatel — Agência Nacional de Telecomunicações
• Microsoft Cortana SDK for Harman Open Source Components

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>