harman kardon Citation Sub S Wireless Subwoofer User Guide

June 6, 2024
harman Kardon

harman kardon Citation Sub S Wireless Subwoofer

PRODUCT TOUR

BACK

GET STARTED

CONNECT TO ANOTHER SPEAKER

SPECIFICATIONS

  • Model Name: CITATION SUB S
  • Signal-to-noise ratio: > 80 dB
  • Output power: 100 W RMS
  • Power Supply: 100 – 240 V ~ 50 / 60 Hz
  • Operating temperature: 0°C – 45°C
  • 5G WISA transmitter power: < 14 dBm
  • 5G WISA modulation: OFDM, BPSK, QPSK, 16QAM
  • 5G WISA transmitter frequency range: 5.15 – 5.35 GHz, 5.47 – 5.725 GHz, 5.725 – 5.825 GHz
  • Dimensions (W x H x D): 248 x 380 x 248 mm (9.8” x 15.0” x 9.8”)
  • Weight: 6.15 kg (13.56 lb)
  • Packaging Dimensions (W x H x D): 322 x 430 x 317 mm (12.7” x 16.9” x 12.5”)
  • Packaging Weight (Gross): 7.63kg (16.82 lb)

Note: CITATION SUB S is in compliance with European Commission Regulation (EC) No 1275/2008 and (EU) No 801/2013.

Power consumption

  • Off Mode: N/A
  • Standby: N/A
  • Network Standby*: 2.0 Watts
    Time to networked standby: < 20 minutes
  • This product is designed to be instantly on and ready to receive signal from WiSA Tx Unit at a moment’s notice, wireless connection must remain active at all times to ensure proper operation. The product is in compliance with the European Union energy legislation. The product will enter into networked standby after 20 minutes without operation, after which it can be re-activated via wireless.

This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B) / NMB-3 (B).
IC Caution:
User should also be advised that:
(i) the device for operation in the band 5150 – 5250 MHz is only for indoor use to reduce the potential for harmful interference to cochannel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250 – 5350 MHz and 5470 – 5725 MHz shall comply with the e.i.r.p. limit: and
(iii) the maximum antenna gain permitted for devices in the band 5725 – 5825 MHz shall comply with the e.i.r.p. limits specified for point-topoint and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250 – 5350 MHz and 5650 – 5850 MHz and that these radars could cause interference and/ or damage to LE- LAN devices.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device. No configuration controls are provided for this wireless equipment allowing any change in the frequency of operations outside the FCC grant of authorization for US operation according to Part 15.407 of the FCC rules.
FCC/IC Radiation Exposure Statement: This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Use Restriction: This device is restricted to indoor use when operating in the 5150 to 5350 MHz frequency range in following countries:

Belgium (BE), Greece (EL), Lithuania (LT), Portugal (PT), Bulgaria (BG), Spain BG ES LU RO (ES), Luxembourg (LU), Romania (RO), Czech Republic (CZ), France (FR), Hungary (HU), Slovenia (SI), Denmark DK HR MT SK (DK), Croatia (HR), Malta (MT), Slovakia (SK), Germany (DE), Italy (IT), Netherlands (NL), Finland (FI), Estonia EE CY AT SE (EE), Cyprus (CY), Austria (AT), Sweden (SE), Ireland (IE), Latvia (LV), Poland (PL) and United Kingdom (UK).

This product contains open source software. For your convenience, the source code and relevant build instruction for software licensed under the GPL is available at http://www.harmankardon.com/ opensource. You may also obtain this information by contacting us at OpenSourceSupport@Harman.com


The WiSA logo is a trademark or registered trademark of WiSA, LLC in the United States and other countries.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

harman Kardon User Manuals

Related Manuals