DRIEAZ LGR 2800i Dehumidifier User Guide
- June 10, 2024
- DRIEAZ
Table of Contents
DRIEAZ LGR 2800i Dehumidifier
Product Information
- The LGR 2800i and LGR 3500i Dehumidifiers are products of Legend Brands, Inc. These dehumidifiers are designed to remove excess moisture from the air and maintain a comfortable humidity level in indoor spaces. The units come with a drain hose for continuous draining and are equipped with an automatic defrost system to prevent ice buildup.
- It is important to note that the dehumidifiers should not be modified or altered in any way, and only replacement parts authorized by Legend Brands should be used to prevent hazards and voiding of the warranty. The units should also not be used in environments with corrosive chemicals or by persons with reduced physical, sensory, or mental capabilities.
Product Usage Instructions
- Set the unit upright before use. Do not transport or store the unit in a horizontal position as it may cause damage. If the unit has been in a horizontal position, let it stand upright for at least 30 minutes before turning it on.
- Uncoil and straighten the entire drain hose before use. Do not leave any part of the hose coiled on the unit, and do not place the end of the hose higher than 20 ft (6 m) above the bottom of the unit.
- Plug the electrical cord into a GFCI-protected 120-volt outlet rated for at least 15 amps.
- During operation, do not turn off or move the unit until it has returned to normal operating mode.
- At the end of the job, gently rock the machine to ensure any water remaining on interior surfaces falls into the sump area. Press the PURGE key to complete the purge cycle before turning off the unit.
- Do not unplug the unit during the defrost cycle and keep it upright on a horizontal surface until all water has been purged.
- Coil the power cord and hose and place it in the storage pockets for proper storage.
- For proper disposal, take the unit to a recycler licensed to process refrigeration equipment.
It is also important to note that this product may expose you to chemicals, including lead and phthalates, known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to P65Warnings.ca.gov
SAFETY INSTRUCTION
- WARNING! Do not alter or modify your unit in any way.
- Use only replacement parts authorized by Legend Brands. Modifications or use of unapproved parts could create a hazard and will void your warranty. Contact your local distributor for assistance.
- WARNING! Explosion or combustion hazard due to flammable refrigerant.
- Do not drill into or braze the dehumidifier.
- Do not attempt to service the refrigeration system! Only authorized service personnel should service the refrigeration system.
- Be aware that refrigerant gases can be odorless.
- WARNING! Electric shock hazard, rotating fan, hot surface hazards. Unplug unit before opening cover for cleaning or servicing. Unit must be grounded.
- Inspect the power cord before use. If cord is damaged, do not use. Always grasp the plug (not the cord) to unplug.
- Insert a three-prong plug-on power cord into a matching electrically grounded outlet. Do not use adapter. Never cut off third prong. Do not use an extension cord.
- The unit must be operated on a 120V/60Hz circuit protected by a Ground Fault Circuit Interrupter (GFCI) device.
- Keep motor and wiring dry.
- Do not attempt to repair the unit. For Authorized Service
- Centers, contact Legend Brands.
- NOTICE: Do not use in environments where corrosive chemicals are present, such as chlorine.
- NOTICE: The unit should not be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Children should not be allowed to play with the unit.
- For proper disposal, this unit should be taken to a recycler licensed to process refrigeration equipment
OPERATING YOUR DEHUMIDIFIER
Set unit upright
-
NOTICE: Do not transport or store the unit in a horizontal position, as doing so can possibly damage the unit. If the unit has been placed in a horizontal position, set it upright and let it stand for at least 30 minutes before turning it on. Set up drain hose Unwrap the entire hose and place the unattached end in a sink, drain, bucket or outdoors – anywhere that water can drain out safely. If you use a bucket or other container, check it regularly to prevent overflows.
NOTICE: Uncoil and straighten the entire drain hose. Do not leave any part of the hose coiled on the unit and do not place the end of the hose higher than 20 ft. (6 m) above the bottom of the unit. Plug-in the electrical cord -
The dehumidifier should be plugged into a GFCI-protected 120 volt outlet rated for at least 15 amps.
AT THE END OF THE JOB
- NOTICE: To ensure all water is removed from the dehumidifier, the unit will complete the defrost cycle even if the unit is turned off. Do not unplug the unit during the defrost cycle, and keep it upright on a horizontal surface until all water has been purged.
- Do not turn unit off or move it until it has returned to normal operating mode.
- Gently rock the machine to ensure any water remaining on interior surfaces falls into the sump area.
- Press the PURGE key. When the purge cycle is complete, turn the unit off.
- Coil power cord and hose and place it in the storage pockets.
WARNING: This product may expose you to chemicals, including lead and phthalates, known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to P65Warnings.ca.gov
- CONTAINS: FCC ID 2ADHKWINC3400; IC 20266- ATWINC3400; CAN-ICES-003(B)/MB-003(B)
- Item #110128 & #110133
- Patents:http://www.LBpatents.com
- LEGEND BRANDS, INC.
- 15180 Josh Wilson Road, Burlington, WA 98233
- Phone:800-932-3030 LegendBrands.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>