ARDESTO JEG-800 Centrifugal Juicer Instruction Manual
- June 10, 2024
- ARDESTO
Table of Contents
JEG-800 Centrifugal Juicer
Instruction Manual
EQUIPMENT
- Unassembled juicer – 1 pc
- Juice container – 1 pc
- Instruction manual (warranty card is included) – 1 pc
IMPORTANT SAFETY INSTRUCTIONS
-
Read this instruction manual carefully before using the device, save it for future reference.
-
The device must be installed on a stable, dry and level surface and used in accordance with the instructions given in this instruction manual.
-
Do not expose the device to sudden temperature changes. A sudden change in temperature (for example, bringing the device from a cold place into a warm room) can cause condensation of moisture inside the device and disrupt its performance when turned on. The device should be in a warm room for at least 1.5 hours. Putting the device into operation after transportation should be carried out no earlier than 1.5 hours after bringing it into the room.
-
Ensure that the power cord does not hang over the edge of a table or counter, bend or twist, or touch hot surfaces.
-
Before use, make sure that the mains voltage corresponds to the nominal value indicated on the product.
-
To avoid risks, do not connect the device to the timer.
-
Before use, check for damage to all parts of the device, the power cord, the outlet, and if there is damage or deformation, stop using the juicer and contact an authorized service center.
-
The device is intended for household use only. Do not use for commercial purposes. Use the device only for its intended purpose.
-
Do not use the device outdoors.
-
To avoid the risk of electric shock, do not immerse the device in water or other liquids.
-
Do not use the device if the device or power cord is damaged.
-
Do not attempt to repair or modify the device yourself. Contact an authorized service center for help.
-
If the power cord is damaged, it must be replaced by the manufacturer, service center or similarly qualified personnel in order to avoid a hazard.
-
Assemble and disassemble the device only as indicated in this manual.
-
Before removing, installing or repairing any part of the juicer, disconnect it from the power supply.
-
Before turning on the device, make sure that all parts are installed correctly.
-
Before starting to use the juicer, make sure that the filter is installed correctly, then install the cover, lock the handle tightly, and then turn on the device. Do not open the cover while using the device.
-
Before turning on the device, make sure that the cover of the juicer is installed correctly and securely locked. Do not unfasten the clamps while the device is in operation.
-
Use only accessories recommended by the manufacturer.
-
It is forbidden to disinfect the parts of the device in the disinfection cabinet or to steam and boil.
-
Filter blades are very sharp; to avoid danger, wash the filter under running water, do not wash it with your hands.
WARNING! Do not use the appliance if the rotating sieve is damaged. -
Do not use any other object to push vegetables/fruits except the pusher provided. Keep your eyes away from the loading hole.
-
During the first use of the device, a slight specific smell and sparks may appear; this is a normal phenomenon. After the engine has been running for a while, the smell and sparks will disappear.
-
To avoid damage during use, do not put hard foods (such as nuts), high-fiber foods (such as sugar cane), non-juicy fruits (such as bananas) into the juicer.
-
If products are stuck in the loading hole, do not push them through with your fingers, but use a pusher. If the fruit/vegetables are stuck and you cannot push them through with the pusher, turn off the appliance and disassemble it to remove the remaining fruit/vegetables.
-
Make sure that hard objects do not fall into the loading hole – this can damage the device. To avoid injury, do not put your fingers in the loading hole.
-
To avoid injury, avoid contact with moving parts of the device.
-
It is forbidden to use the device empty (without products) or to overload it.
-
Do not leave the device unattended when it is in operation. Close supervision is required if the device is used by or around children.
-
When making juice, make sure that the juice collector and pulp container are not overflowing. If they are full, turn off and clean the device.
-
Before pouring the juice from the bowl, disconnect the device from the electrical network.
-
In order to extend the service life of the juicer, overheating protection is installed in the motor. If the motor runs for a long period of time or is overloaded, the overheat protection is triggered and the device automatically shuts down. After stopping the motor, remove the plug from the outlet, wait until the motor cools down (about 30 minutes), then turn on the juicer again.
-
Unplug the device after each use.
-
Unplug the device when not in use, before removing or installing parts, and before cleaning the device.
-
Always turn the switch to the OFF position after use.
Before disassembling the device, make sure that the engine has stopped completely. -
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children should not play with the device. Cleaning and user maintenance should not be performed by unsupervised children.
-
Keep the device out of the reach of children. 38. Store the device in a dry place, avoid direct sunlight.
Note: The images in the instructions are for reference only.
The actual device is likely to be different.
DIAGRAM OF NAME AND POSITION OF MAIN COMPONENTS
- Pushing bar
- Transparent cover
- Juicing net
- Middle ring
- Handle
- Main body
- Juicer jug
INSTRUCTIONS FOR USE
Before using your juice extractor
Follow the assembling instructions listed below before using your juice
extractor:
- Before you start assembling your juice extractor, make sure it is unplugged and it is placed on a dry and leveled surface.
- Place middle ring on top of the motor base.
- Place the stainless steel filter on the middle ring, turning it until it fits into the grooves of the motor shaft.
- Place transparent cover on top of the filter.
- Raise the handle/safety locking arm and place it on the grooves on the sides of the transparent cover. This is a safety feature that will ensure the unit will not operate unless the transparent cover is properly locked. The safety locking arm should now be up and locked into place on top of the transparent cover.
- Place the juice cup under the spout located on the right hand side of the juicer.
OPERATING INSTRUCTIONS
- Prepare your fruits and vegetables by washing them thoroughly and peeling off those that need the skin removed.
- Your juicer features an extra wide chute and thus most fruits and vegetables such as apples, carrots, pears and others will not need to be cut into small pieces if they fit in the chute.
- Make sure your juice extractor is properly assembled. Please follow the instructions from the section “Before Using Your Juice Extractor.”
- Ensure the juice extractor and its accessories are clean by following the cleaning and maintenance section of this manual.
- Place the juicer jug or other container/glass you may wish to use to collect the juice under the spout. Do not allow the residue barrel to overfill as this may cause the unit to stall.
- Plug the power cord into an electrical outlet and turn the power on “I”.
- Once the juicer is on, place the fruits and vegetables into the feeding tube and use pushing bar to drive them down slowly. In order to extract the maximum amount of juice, it is important to push the pushing bar slowly.
- The juice extractor will separate the juice and residue in the juicer jug and barrel automatically while you are juicing.
Note: Never use hand or fingers to push food down into the feeding tube
or clean the feeding tube, always use the pushing bar provided.
OPERATION TIME
This juice extractor is designed with rotation switches of O grading, I
grading, II grading (O for stop, I for weak grading, II for strong grading).
For juicing hard fruits, select strong grading II, after operating for 1 min,
stop for 1 min, then use again. After above operation is performed for three
times, stop for 15 min, do not operate until the motor is cool down. In this
way, service life of this device would be prolonged and it will serve you more
efficiently.
AFTER USING YOUR JUICE EXTRACTOR
Before cleaning and storing your juice extractor, follow the
instructions below to disassemble the unit:
- Turn juice extractor off “O” and unplug it from the electrical outlet.
- Unlock the safety locking arm and move it down to release the transparent cover.
- Lift the transparent cover up and remove it from the device.
- Lift up the juicing net and middle ring, then remove the residue barrel.
Warning: The stainless steel filter contains small sharp blades to cutand
process fruits and vegetables. Do not touch blades when handling the filter.
CLEANING
- After disassembling all removable parts of the juice extractor, wash them by hand with warm soapy water or in the dishwasher (pushing bar, transparent cover, middle ring, residue barrel, juicer cup only). If the residue dries out in the residue barrel or the filter, let it soak in water for approximately 10 minutes before washing it.
- Wipe the main body with a damp cloth. Do not immerse the main body in water or any other liquid.
- It is very important to keep the filter very clean, free of residues blocking the holes in order to ensure optimal performance. Use a nylon brush to clean it thoroughly, if necessary.
MAINTENANCE
Some plastic parts might stain when in contact with some fruits and vegetables
for too long. In order to avoid this from happening, all parts should be
washed immediately after each use.
TIPS AND SUGGESTIONS
- Do not place any fruits or vegetables until you turn the unit on. Allow unit to run for a few seconds before you start juicing. At the beginning of usage, the motor works in running-in phase, there may be slight peculiar smell and spark, this is normal, after the motor works for some period, the above phenomenon will disappear.
- Do not allow the residue barrel to overfill as this may cause damage of the unit.
- Ensure to remove large pits from fruits such as peach, mango etc as they can damage the unit.
- Do not use bananas as they do not contain juice and will clog the unit.
- If the device has not been used for a long time, please store it in a dry place.
CORRECT DISPOSAL OF THIS PRODUCT
** This marking indicates that this product should not be disposed with
other household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe
recycling.
The manufacturer reserves the right to make changes in the technical
characteristics and design of the products that do not impair the operational
qualities.
Warranty conditions:**
The plant guarantees normal operation of the product within 12 months from the
date of the sale, provided that the consumer complies with the rules of
operation and care provided by this Manual.
Service life of the product is 5 years. In order to avoid any misunderstanding
we kindly ask you to carefully study the Owner’s Manual, the terms of
warranty, and check the correctness of filling the Warranty Card. The Warranty
Card is valid only if the following information is correctly and clearly
stated: model, serial number of the product, date of sale, clear seals of the
companyseller, signature of the buyer. The model and serial number of the
product must correspond to those specified in the Warranty Card.
If these terms are violated, and if the information specified in the Warranty
Card is changed, erased or rewritten, the Warranty Card is considered invalid.
Setup and installation (assembly, connection, etc.) of the appliance are
described in the attached documentation; they can be carried out both by the
user, and by specialists having the necessary qualification sent by USC or
selling companies (on a paid basis). In this case, the person (the
institution) installing the appliance shall be responsible for the correctness
and quality of installation (setup). Please pay attention to the importance of
the correct installation of the appliance, both for its reliable operation,
and for obtaining warranty and free service. Require the installation
specialist to enter all the necessary information about the installation in
the Warranty Card.
In case of failure of the appliance during the warranty period by the fault of
the manufacturer, the owner is entitled to free warranty repair upon
presentation of the correctly filled Warranty Card together with the appliance
in the factory configuration packed in the original packaging to the warranty
workshop or the place of its purchase. Satisfaction of the customer’s claim
due to the fault of the manufacturer shall be made in accordance with the law
«On Protection of Consumers’ Rights». In the case of warranty repair the
warranty period shall be extended for the period of repair and shipment.
WARRANTY CARD
Dear Buyer! Congratulations on your purchase of the ARDESTO brand appliance,
which was designed and manufactured in accordance with the highest quality
standards, and we thank you for choosing this particular instrument.
We ask you to keep the coupon during the warranty period. When purchasing a
product, require a full warranty card.
-
Warranty service is carried out only if there is a correctly and clearly filled original warranty card, which indicates: product model, date of sale, serial number, warranty service period, and the seller’s seal.*
-
The service life of household appliances is 5 years.
-
The product is intended for consumer use. When using the product in commercial activities, the seller / manufacturer does not bear warranty obligations, after-sales service is performed on a paid basis.
-
Warranty repair is carried out within the period specified in the warranty card for the product in an authorized service center on the conditions and terms determined by applicable law.
-
The product is withdrawn from the warranty in case of violation by the consumer of the operating rules set forth in the instruction manual.
-
The product is removed from warranty service in the following cases:
• misuse and non-consumer use;
• mechanical damage;
• damage caused by the ingress of foreign objects, substances, liquids, insects;
• damage caused by natural disasters (rain, wind, lightning, etc.), fire, domestic factors (excessive humidity, dust, aggressive environment, etc.)
• damage caused by non-compliance of power and cable network parameters with state standards and other similar factors;
• when operating equipment in the power supply network with a missing single ground loop;
• in case of violation of seals installed on the product;
• lack of serial number of the device, or inability to identify it. -
The warranty does not cover consumables and accessories, as well as filters, shelves, drawers, stands and other containers for storing products.
-
The warranty period is 12 months from the date of sale.
- Tear-off maintenance tickets are provided by an authorized service center.
The completeness of the product is checked. I have read the terms of the warranty service, no complaints.
Customer Signature
Product information
Product ____
Model ____
Serial number ____
Seller Information ____
Trade organization name ____
The address ____
Date of sale ____
Seller stamp ____
Warranty card ____
Coupon № 3
Seller stamp
Date of application ____
Cause of damage ____
Date of completion ____
Coupon № 2
Seller stamp ____
Date of application ____
Cause of damage ____
Date of completion ____
Coupon № 1
Seller stamp ____
Date of the application ____
Cause of damage ____
Date of completion
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>