sensorswitch Time Delay Programming Instructions
- June 3, 2024
- sensorswitch
Table of Contents
sensor switch Time Delay Programming
Time Delay Programming Instructions
- Push and hold button until LED flashes rapidly (approximately 6 seconds). Release button.
- Press button twice to enter Time Delay adjustment mode.
- The LED will flash back the current Time Delay setting according to below table (i.e. 5 flashes for 10 minute Time Delay). Wait approximately 3 seconds
- Press button the number of times for the desired setting (i.e., press twice for 2.5 minutes Time Delay).
- LED will flash back this new setting, (repeated up to 10 times).
- Press button down again until LED flashes rapidly (approximately 6 seconds). Release button.
- Press button twice to verify Time Delay has been reprogrammed.
- LED will flash back twice indicating acceptance of new setting
Time Delay Settings Table
Push the Button the number of increments desired
1 ~ 30 Sec 4 ~ 7.5 Min 7 ~ 15.0 Min
2 ~ 2.5 Min 5 ~ 10.0 Min* 8 ~ 17.5 Min
3 ~ 5.0 Min 6 ~ 12.5 Min 9 ~ 20.0 Min
- 900 Northrop Road
- Wallingford, CT 06492
- 1.800.PASSIVE
- FX 203.269.9621
Documents / Resources
|
sensorswitch Time Delay
Programming
[pdf] Instructions
Time Delay Programming, Time Delay, Programming, Time Programming
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>