ARDESTO JEG-1500S Slow Juicer Instruction Manual
- June 10, 2024
- ARDESTO
Table of Contents
JEG-1500S Slow Juicer
Instruction Manual
EQUIPMENT
- Unassembled juicer – 1 pc
- Juice container – 1 pc
- Pulp container – 1 pc
- Cleaning brush – 1 pc
- Instruction manual (warranty card is included) – 1 pc
SAFETY INSTRUCTIONS
- Read this instruction manual carefully before using the device, save it for future reference.
- The device must be installed on a stable, dry and level surface and used in accordance with the instructions given in this instruction manual.
- Do not expose the device to sudden temperature changes. A sudden change in temperature (for example, bringing the device from a cold place into a warm room) can cause condensation of moisture inside the device and disrupt its performance when turned on. The device should be in a warm room for at least 1.5 hours. Putting the device into operation after transportation should be carried out no earlier than 1.5 hours after bringing it into the room.
- Ensure that the power cord does not hang over the edge of a table or counter, bend or twist, or touch hot surfaces.
- Before use, make sure that the mains voltage corresponds to the nominal value indicated on the product.
- To avoid risks, do not connect the device to the timer.
- Before use, check for damage to all parts of the device, the power cord, the outlet, and if there is damage or deformation, stop using the juicer and contact an authorized service center.
- The device is intended for household use only. Do not use for commercial purposes. Use the device only for its intended purpose.
- Do not use the device outdoors.
- To avoid the risk of electric shock, do not immerse the device in water or other liquids.
- WARNING! Do not use the appliance if the rotating sieve is damaged.
- Do not use the device if the device or power cord is damaged.
- Do not attempt to repair or modify the device yourself. Contact an authorized service center for help.
- If the power cord is damaged, it must be replaced by the manufacturer, service center or similarly qualified personnel in order to avoid a hazard.
- Assemble and disassemble the device only as indicated in this manual.
- Before removing, installing or repairing any part of the juicer, disconnect it from the power supply.
- Before turning on the device, make sure that all parts are installed correctly.
- Use only accessories recommended by the manufacturer.
- It is forbidden to disinfect the parts of the device in the disinfection cabinet or to steam and boil.
- Do not use any other object to push vegetables/fruits except the pusher provided. Keep your eyes away from the loading hole.
- To avoid damage during use, do not put hard foods (such as nuts), high-fiber foods (such as sugar cane), non-juicy fruits (such as bananas) into the juicer.
- If products are stuck in the loading hole, do not push them through with your fingers, but use a pusher. If the fruit/vegetables are stuck and you cannot push them through with the pusher, turn off the appliance and disassemble it to remove the remaining fruit/ vegetables.
- Make sure that hard objects do not fall into the loading hole – this can damage the device. To avoid injury, do not put your fingers in the loading hole.
- To avoid injury, avoid contact with moving parts of the device.
- It is forbidden to use the device empty (without products) or to overload it.
- Do not leave the device unattended when it is in operation. Close supervision is required if the device is used by or around children.
- In order to extend the service life of the juicer, overheating protection is installed in the motor. If the motor runs for a long period of time or is overloaded, the overheat protection is triggered and the device automatically shuts down. After stopping the motor, remove the plug from the outlet, wait until the motor cools down (about 30 minutes), then turn on the juicer again.
- Unplug the device after each use.
- Unplug the device when not in use, before removing or installing parts, and before cleaning the device.
- Always turn the switch to the OFF position after use. Before disassembling the device, make sure that the engine has stopped completely.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children should not play with the device. Cleaning and user maintenance should not be performed by unsupervised children.
- Keep the device out of the reach of children. 33. Store the device in a dry place, avoid direct sunlight.
DIAGRAM OF NAME AND POSITION OF MAIN COMPONENTS
❶ Pusher
❷ Auger
❸ Main unit
❹ Chamber| ❺ Juice cup
❻ Pulp cup
❼ Filter
❽ Cap
---|---
Note: The images in the instructions are for reference only. The actual device is likely to be different.
OPERATION
Read and understand this entire owner’s manual, including all safety
information, before plugging in or using this product.
Failure to do so could result in electric shock, fire, serious injury, or
death.
ASSEMBLING
- Position the chamber properly on the product body, while pressing the button on the edge.
- Install the auger firmly inside the slow juicer’s chamber. Ensure it has been firmly positioned inside.
- Position the filter inside the chamber.
- Fasten the cap and fix it tightly.
USAGE
Simply follow the instructions provided below when using the juicer.
- After assembly correctly, please turn on the device to run several seconds for warm up and make sure in good condition.
- Best use with fresh fruits which is rich in water and nutrition.
- Wash and cut fruits in sizes that can fit into the tube.
- Remove the pits and hard core from the fruits.
- Put food materials into feeding tube and slightly press down slowly using the fruit pusher.
When the device is stopped during juicing
Did you use more than 10mins?
If Yes, wait for 5 minutes for the slow juicer to cool down. Press and hold
the “REV” button for 2-5 seconds to push the fruits upwards.
Press «OND button to resume juicing.
NOTES:
- Do not force in the fruits during juicing to prevent damage to the Auger and Micro-Mesh Filter.
- This device is not suitable for juicing cereal and sugarcane.
- Do not juice continuously for more than 15mins.
CLEAN AND MAINTENANCE
Simply follow the instructions provided below in cleaning the juicer.
- Turn ON the device and pour in water, this will immediately push out the remaining residue left in the chamber and Auger.
- Turn OFF the device and unplug the power adapter from the power outlet.
- Remove the chamber, the filter, and the cap separately, then wash them with water until clean.
- Please store the device in a dry and clean place to avoid the direct shining from the sun after clean.
TROUBLESHOOTING
Please check the details below before calling our Technical Support for repair
or service.
Device does not start
Check if the device is plugged properly to a power outlet.
Check the parts of juicer and make sure that each component is assembled and
attached correctly.
Juice output yield is low
Ensure that the rubber at the bottom of chamber is plugged tightly and firmly
to the chamber.
Fresh fruits give the highest level of juice content.
Device stops working
Check if you have put excessive food materials in the juicer.
Check food material composition (e.g. cords, hard fruit core) that may have
caused blockage.
Press the REV Button for 3 to 5 seconds, and then press the ON button. If the
device is still not working, simply turn it OFF let it cool down, dissemble
and clean.
Device emits sound while juicing and vibrates
It is normal for the juicer to produce some sound as it squeezes the fruits or
vegetables into marsh.
Depending on the type of ingredient, hard ingredients (such as carrot,
beetroot, radish and etc.) may cause the juicer to emit louder than soft
ingredients.
If the problem persists, contact an authorized service center.
CORRECT DISPOSAL OF THIS PRODUCT
**** This marking indicates that this product should not be disposed with
other household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe
recycling.
The manufacturer reserves the right to make changes in the technical
characteristics and design of the products that do not impair the operational
qualities.
Warranty conditions:
The plant guarantees normal operation of the product within 12 months from the
date of the sale, provided that the consumer complies with the rules of
operation and care provided by this Manual.
Service life of the product is 5 years. In order to avoid any misunderstanding
we kindly ask you to carefully study the Owner’s Manual, the terms of
warranty, and check the correctness of filling the Warranty Card. The Warranty
Card is valid only if the following information is correctly and clearly
stated: model, serial number of the product, date of sale, clear seals of the
companyseller, signature of the buyer. The model and serial number of the
product must correspond to those specified in the Warranty Card.
If these terms are violated, and if the information specified in the Warranty
Card is changed, erased or rewritten, the Warranty Card is considered invalid.
Setup and installation (assembly, connection, etc.) of the appliance are
described in the attached documentation; they can be carried out both by the
user, and by specialists having the necessary qualification sent by USC or
selling companies (on a paid basis). In this case, the person (the
institution) installing the appliance shall be responsible for the correctness
and quality of installation (setup). Please pay attention to the importance of
the correct installation of the appliance, both for its reliable operation,
and for obtaining warranty and free service. Require the installation
specialist to enter all the necessary information about the installation in
the Warranty Card.
In case of failure of the appliance during the warranty period by the fault of
the manufacturer, the owner is entitled to free warranty repair upon
presentation of the correctly filled Warranty Card together with the appliance
in the factory configuration packed in the original packaging to the warranty
workshop or the place of its purchase. Satisfaction of the customer’s claim
due to the fault of the manufacturer shall be made in accordance with the law
«On Protection of Consumers’ Rights». In the case of warranty repair the
warranty period shall be extended for the period of repair and shipment.
WARRANTY CARD
Dear Buyer! Congratulations on your purchase of the ARDESTO brand
appliance, which was designed and manufactured in accordance with the highest
quality standards, and we thank you for choosing this particular instrument.
We ask you to keep the coupon during the warranty period. When purchasing a
product, require a full warranty card.
-
Warranty service is carried out only if there is a correctly and clearly filled original warranty card, which indicates: product model, date of sale, serial number, warranty service period, and the seller’s seal. *
-
The service life of household appliances is 5 years.
-
The product is intended for consumer use. When using the product in commercial activities, the seller / manufacturer does not bear warranty obligations, after-sales service
is performed on a paid basis. -
Warranty repair is carried out within the period specified in the warranty card for the product in an authorized service center on the conditions and terms determined by applicable law.
-
The product is withdrawn from the warranty in case of violation by the consumer of the operating rules set forth in the instruction manual.
-
The product is removed from warranty service in the following cases:
• misuse and non-consumer use;
• mechanical damage;
• damage caused by the ingress of foreign objects, substances, liquids, insects;
• damage caused by natural disasters (rain, wind, lightning, etc.), fire, domestic factors (excessive humidity, dust, aggressive environment, etc.)
• damage caused by non-compliance of power and cable network parameters with state standards and other similar factors;
• when operating equipment in the power supply network with a missing single ground loop;
• in case of violation of seals installed on the product;
• lack of serial number of the device, or inability to identify it. -
The warranty does not cover consumables and accessories, as well as filters, shelves, drawers, stands and other containers for storing products.
-
The warranty period is 12 months from the date of sale.
- Tear-off maintenance tickets are provided by an authorized service center.
The completeness of the product is checked. I have read the terms of the warranty service, no complaints.
Customer Signature ____
Product information
Product ____
Model ____
Serial number ____
Seller Information ____
Trade organization name ____
The address ____
Date of sale ____
Seller stamp ____
Warranty card ____
Coupon № 3
Seller stamp
Date of application ____
Cause of damage ____
Date of completion ____
Coupon № 2
Seller stamp ____
Date of application ____
Cause of damage ____
Date of completion ____
Coupon № 1
Seller stamp ____
Date of the application ____
Cause of damage ____
Date of completion ___
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>