PICOBOX FM Guard Updater Tool User Guide
- June 11, 2024
- PICOBOX
Table of Contents
FM Guard Updater Tool
Document Control No.: 2022-10-001 Revision No.: 0001
FM GUARD UPDATER TOOL GUIDE
CHAPTER I: INTRODUCTION
Thank you for purchasing the PICOBOX Facility Management Controller (FM Guard).
FM Guard is an industrial DIN rail device used as remote surveillance, or as a low-priced autonomous system, which monitors and controls different process on distant localities. This device is powerful, easy to configure, and to install.
FM Guard uses two methods to update the firmware: First is through online update wherein the FM Guard must be connected to internet; Second is through direct update or through the FM Guard Updater Tool wherein the FM Guard must be connected directly to a laptop or a PC via debugging cable.
This manual will serve as a guide on how to update FM Guard’s firmware using the Updater Tool.
CHAPTER II: FM GUARD UPDATER TOOL
FM Guard updater is a tool used to directly update the FM Guard’s firmware. This tool can be downloaded on our website, https://linkwisetech.com. The updated tool is an executable file and it doesn’t require any installation.
A USB A to mini–USB B cable is needed to connect the FM Guard directly to laptop or PC (please note that this is included together with the FM Guard device upon purchase).
Image 1: USB A to Mini-USB B
CHAPTER III: FIRMWARE UPDATE
Downloading the tool and firmware
In order to update the FM Guard to its latest version, the Updater tool and firmware must be downloaded first. You may access it on our website, just go through the ‘Products’ link then click the FMGUARD section or you may use this link: https://linkwisetech.com/products/facility-monitoring- system/picobox/fm-guard/.
Connecting the FM Guard device to your computer
From your laptop/PC, plug the USB A to mini–USB B cable to the FM Guard device and laptop/PC to build a connection.
FOR DIRECT FIRMWARE UPDATE
Image 2: FM Guard Bottom View
Running the Updater Tool
After downloading the tool and firmware and connecting the FM Guard to you laptop/PC, extract the downloaded Updater tool and run the executable file.
Image 3: FM Guard Updater Tool
On the lower left of the Updater tool window, you will the following details:
a. Connection Status – If Laptop/PC is connected or not to the FM Guard;
b. Serial number of the FM Guard;
c. Current kernel version; and
d. FM Guard version.
Setup page
Setup page is the settings for communication port setup. It automatically recognizes what USB port used.
Image 4: Setup Page
File page
File page is the application’s page that selects a firmware file (.rpc) to be uploaded to the connected FM Guard.
Image 5: Setup Page
Once the firmware file is selected, it will appear in the main screen of the updater tool.
Image 6: Updater Tool with selected firmware
Transferring of firmware
After selecting the firmware file, click the ‘Transfer’ button. The file will start to upload to the connected FM Guard. Wait until the firmware uploading status is finished.
Image 7: Updater Tool Updating Progress
When uploading of firmware is done, the FM Guard will automatically restart in order for the uploaded firmware to take effect.
About page
About page is the information page about the FM Guard Updater Tool.
END OF MANUAL
Documents / Resources
|
PICOBOX FM Guard Updater
Tool
[pdf] User Guide
FM Guard Updater Tool, FM, Guard Updater Tool, Updater Tool
---|---
References
- Linkwise Technology Group of Companies
- Linkwise Technology Group of Companies
- Picobox FMGuard | Facility Monitoring System
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>