GE APPLIANCES RAVRG4 Large Access Panel with Reversible Hinges and Return Air Grille Instruction Manual
- June 11, 2024
- GE Appliances
Table of Contents
GE APPLIANCES RAVRG4 Large Access Panel with Reversible Hinges and Return
Air Grille Instruction Manual
Installation Instructions
Before you begin – Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the
Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for
future reference.
PARTS INCLUDED
- Return Air Grille/Access Panel
- (57 %” Tall x 29 %” Wide)
- Mounting Frame
- Access Panel Screws
Materials Needed (Field Supplied Parts)
- 24″ x 20″ Filter (2″ maximum thickness) (Do not use if using a chassis mounted filter)
- Mounting screws, 4 #8 x 1 IA”
INSTALLATION OVERVIEW
INSTALLATION INSTRUCTION
STEP 1: Mounting the Access Panel Frame
Remove the Access panel from the frame by removing the 4 screws. Set the
panel aside and retain the screws.
For a left hand hinge mount the door frame with the three hinge tabs on the
left side.
For a right hand hinge mount the door frame with the three hinge tabs on the
right side.
After determining the left or right hinge position, secure with the four
field supplied mounting screws. The Access panel frame must be plumb
(vertical) and level.
STEP 2: Mounting the Access Panel on the Mounting Frame
Install the Access Panel onto the Mounting frame.
Insert the Access panel slots over the tabs on the frame.
Be sure that the access panel has engaged all three tabs and the panel is
against the mounting bracket.
STEP 3: Securing the Access Panel
To secure the Access panel to the mounting frame, use the four flat head
screws removed in Step 1.
For 1″ Thick Air Filters
When using a 1″ thick air filter, bend the four tabs inward to hold the filter
securely against the louvers.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>