eta 0048 Lavado Electric Hand Beater Instruction Manual

: June 5, 2024
: ETA

Table of Contents

SAFETY WARNING
DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)
PREPARATION FOR USE
USE OF THE ACCESSORIES (Fig. 2)
MAINTENANCE
ENVIRONMENTAL PROTECTION
TECHNICAL DATA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

0048 Lavado Electric Hand Beater
Instruction Manual

Electric hand beater
eta 0048

INSTRUCTIONS FOR USE

SAFETY WARNING

Before the first use, read all the instructions for use carefully, look at the picture and keep the instructions.
Check whether the data on the type label corresponds with the voltage in your socket.
Do not insert or take out the plug to or from a socket with wet hands and do not pull the power cord!
The appliance is intended for use in households only and for similar use!
This appliance must not be used by children. Keep the device and its supply cord out of reach of children.
The device may be used by persons with reduced physical or mental abilities or lack of experience and knowledge only if they are under supervision or they have been instructed about using the appliance safely and understand the potential dangers. Children must not play with the appliance.
Before replacing accessories or accessible parts, which move during operation, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
If the power cord of the appliance is corrupted, it has to be replaced by the producer, its service technician or a similarly qualified person so as to prevent dangerous situations.
Be careful when pouring hot liquid into the food processing device or the mixer because it may spurt out of the appliance because of sudden boil
Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged or if it fell to water. In this case take the appliance to a special service to check its safety and proper function
Always unplug the appliance from power supply if you leave it unattended and before assembly, disassembly or cleaning.
Never leave the appliance unsupervised and check it during the whole time of preparing meals!
Never immerse the drive unit into water or wash it in running water!
Use the appliance in the working position only at places with no risk of turning over and in a sufficient distance from heat sources (e. g. heater, stove, grill, etc.), and wet surfaces (e. g. sinks, wash basins, etc.)
Do not switch on the appliance without ingredients in it!
Use the appliance designed and supplied for this type only. Using another appliance can represent a risk for the operator
Do not combine the appliance (beaters B and hooks C).
Do not insert the appliance into anybody’s holes.
Do not remove the appliance if the drive unit is in operation!
Make sure that the power supply cable does not get between the rotating parts of the accessories.
The work adapters cannot be exchanged when the drive unit is in operation for safety reasons.
Check before every connection of the appliance to the power supply whether switch A1 is in the 0 positions (off) and after completing work always disconnect the appliance from the power supply.
Always unplug the appliance from the power supply if you leave it unattended.
Do not let children use the appliance without supervision!
Do not process food at temperatures exceeding about 80 °C.
Never insert e.g. fingers, fork, knife, spatula, or spoon into rotating parts of the appliance and the accessories.
If the processed food starts to stick to the appliance (e.g. whipping beaters, kneading hooks), switch off the appliance and clean the accessories carefully using a spatula.
Make sure that the appliance does not hit walls of containers strongly when handling the beater.
The power cord must not be damaged by sharp or hot objects, or open fire, it must not be sunk into water or bent over sharp edges.
If you need to use the extension cord, it has to be uncorrupted and it has to comply with the valid standards.
Never use the appliance for any other purpose than for that described in these instructions for use!
The manufacturer is not responsible for damage caused by improper use of the appliance and the accessories (e.g. food deterioration, fire) and its guarantee for the appliance does not apply in situations when the safety warnings above are not complied with.

DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)

A – drive unit
A1 – Multi-function control
A3 – holes of the drive for connecting the accessories
A2 – TURBO button
A4 – power cord
B – whipping beaters
C – kneading hooks

PREPARATION FOR USE

Remove all the packing material and take out the beater with the accessories. Remove all possible adhesion foils, stick-on labels or paper from the appliance. Before the first use, wash the parts that will be in contact with food in hot water with a detergent, rinse them thoroughly with clean water and wipe till dry, or let them dry. Plug the power cord connector A4 to an electric socket.
Using individual levels (A1, A2), (fig. 3)

0………….. off,
1 to 3………. speed options (using for whipping, mixing, kneading),
EJECT………….. ejector (releases the accessories from the drive unit),
TURBO button…………….. the motor works at maximum performance and it is in operation while the button A2 is pushed,
…………………………….can be used at any speed level.

USE OF THE ACCESSORIES (Fig. 2)

Please consider the following tips for preparing food as examples and inspiration, the purpose of which is not to provide instructions, but to show various possibilities of preparing food. The times of food preparation (processing) are given in minutes. We recommend stopping work from time to time, switching off the appliance (position 0) and removing possible food that was stuck on accessories B, C or on the container walls (see par. I. SAFETY WARNING). After finishing work, switch off the beater and unplug the fork of the power supply A4 from the electric socket.
Whipping beaters (B)
Use: Whisking egg whites, mousse, creams, whipping creams, sponge cake dough/batter, mashes, etc.
Switch level: 1 – 3, whipping time about 1 – 5 minutes
Insertion:
The mutual position is given by their construction; for this reason, the mutual interchangeability of the beaters in the holes is not possible. Insert the beaters to the respective holes A3 in the lower part of the drive to the maximum position. Release the beaters by moving the multi-function control A1 in the,, EJECT” arrow direction.
Recommendation
– When whipping, use the substances at room temperature.
– First put liquid ingredients into the bowl and only then put solid ingredients in to achieve the best results.
– First whip at low speed so that the dough does not splash out. Only then you can go to a higher speed.
– If beating is not optimal, make sure that the beater is not greasy, or add a little lemon juice or salt.
– Cool the cream or whipping cream to at least 6 °C before processing (at least 200 ml).
– We recommend using a narrow container for whipping cream.
– Never use whipping beaters for mixing tough materials, such as yeast dough.
Kneading hooks (C)
Use: Preparing spreads, mixing potatoes, spinach, mixing dough, etc.
Switch level : 1 – 3, kneading time about 1 – 5 minutes.
Insertion:
The mutual position is given by their construction; for this reason, mutual interchangeability of the hooks in the holes is not possible. Insert the hooks to the respective holes A3 in the lower part of the drive to the maximum position. Release the hooks by moving the multi-function control A1 in the,, EJECT” arrow direction.
Recommendation
– When kneading, use the substances at room temperature.
– First mix yeast in lukewarm milk. As soon as the dough gets into the shape of a ball, stop kneading as you are used to, or leave the dough to rise according to the recipe.
– When preparing the tough dough, we recommend putting loose ingredients in the bowl first for better mixing and then adding liquid ingredients.
– When preparing more dough, prepare it in several doses.
Warning
– If necessary for inserting, turn the beaters or kneading hooks slightly.
– The plastic ring on a beater or a kneading hook remains invisible. The beater or the kneading hook cannot be inserted further to the appliance.
– Switch on the appliance only when accessories B, and C are immersed in the processed ingredients.
– For mixing or whipping, only one kneading hook or whipping beater can be used in a
suitable container. Choose the size of the container according to the amount of the prepared mass.
– After 10 minutes of continuous operation wait for about 15 minutes, which is necessary for the drive unit to cool down.

MAINTENANCE

Before any handling with the appliance or its maintenance, switch off the appliance and unplug the power supply cord from the electric socket. Do not use rough and aggressive detergents! Clean the drive unit by a soft and wet cloth with a little detergent. Make sure that water does not get inside the appliance. Wash the other accessories right after use in hot water with a little detergent added, rinse them with clean water and wipe them till dry (you can also use a dishwasher). Some ingredients can color the accessories in some way. But this does not affect the function of the appliance and it is not a reason for a claim. This coloring usually disappears in some time. Never dry plastic moldings over a heat source (e.g. heater, stove, radiator).
Storing the appliance and accessories
After cleaning, wind the power supply cord A4 over the back part of the drive unit A. Store the drive unit at a dry, dust-free place, out of reach of children and legally incapacitated people.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for the production of packing, components, and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal, hand them over at the special collection places where they will be accepted free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or at a collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. If the appliance is to be put out of operation, after disconnecting it from the power supply we recommend its cutoff, and in this way, it will not be possible to use the appliance again.
More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to the expiration of the right to guarantee repair!

TECHNICAL DATA

Voltage (V)………………….specified on the type label
Input (W)……………………… specified on the type label
Weight of drive unit (kg) about………………1.0
The product has received ES declaration of conformity according to Act as amended. The product matches the requirements of the below statutory order as amended.

Committee Regulation No. 2006/95/ES as amended, setting the technical requirements of the electrical appliance as low.
Committee Regulation No. 2004/108/ES as amended, setting the technical requirements of products in terms of their electromagnetic compatibility

The product is in conformity with the European Parliament and European Committee Regulation No. 1935/2004/ES re. Materials and objects designed for contact with food.
The manufacturer reserves the right for any insignificant deviations from the standard finished product that do not have any effect on the functioning of the product.
HOUSEHOLD USE ONLY. DO NOT IMMERSE IN WATER TO AVOID THE DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES, OR PLAYPENS. THIS BAG IS NOT A TOY.
PRODUCER: ETA a.s., Zelený pruh 95/97, 147 00 Praha 4-Bráník, Czech Republic.