SOLIGHT WO801-B LED Wall Light for Outdoor Instruction Manual
- June 11, 2024
- Solight
Table of Contents
SOLIGHT WO801-B LED Wall Light for Outdoor
Thank you for purchasing our product. Please read this manual carefully and heed the safety warnings and instructions before installing, using or repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.
Product Information
The WO801-B and WO801-W are products that provide illumination. The WO801-B and WO801-W operate at an AC voltage of 175-265V and have a consumption of 6W. They have dimensions of 100x100x100mm and provide coverage with an IP54 rating. The chromaticity of the product can be set to 3000K, 4000K, or 6000K using the 3CCT switch. The light source of the luminaire is non-replaceable. At the end of its service life, the entire luminaire must be replaced and disposed of in a designated place. The power cord cannot be replaced if damaged, and the unit must no longer be used.
Product Usage Instructions
Before installing, using, or repairing the equipment, please read the manual
carefully and heed the safety warnings and instructions. This will ensure not
only the protection of persons but also the long life of the equipment.
WARNING: Installation may only be carried out by a qualified
professional. Switch off the power supply before starting the installation
process.
Unscrew the side screws holding the back cover.
Drill holes in the wall and insert dowels into them.
Push the power cable through the hole in the cover and then screw the cover to the wall.
Connect the power cord to the luminaire.
Fit the luminaire, and screw it to the back cover.
Switch on the power supply.
Fit the cover.
To set the desired light temperature, use the slider inside the luminaire to adjust the chromaticity switch.
SPECIFICATION
Mark| Operating voltage| Consumption| Angle of
illumination| Chromaticity| Dimensions| Coverage
---|---|---|---|---|---|---
WO801-B| AC175~265V| 6W| 10~100°| 3000K, 4000K, 6000K| 100x100x100mm|
IP54
WO801-W| AC175~265V| 6W| 10~100°| 3000K, 4000K, 6000K| 100x100x100mm|
IP54
INSTALLATION
- Switch off the power supply.
- Unscrew the side screws holding the back cover, drill holes in the wall and insert dowels into them, push the power cable through the hole in the cover and then screw the cover to the wall.
- Connect the power cord to the luminaire.
- Fit the luminaire and screw it to the back cover.
- Switch on the power supply.
- Fit the cover.
Chromaticity switch: use the slider inside the luminaire to set the desired light temperature
WARNING
- Installation may only be carried out by a qualified worker with a qualification according to Decree No. 50/1978 Coll., as amended, at least a knowledgeable worker according to § 5 of Decree No. 50/1978 Coll., as amended.
- Do not cover the luminaire with anything or hang anything on it
- Do not repair or modify the equipment in any way.
The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source. The power cord cannot be replaced if damaged, the unit must no longer be used.
3CCT Switch
SELECT BY SLIDING THE SLIDER ON THE POWER SUPPLY.
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Czech Republic.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>