TRONIC TLS 2 A1 In Car Charger Instruction Manual

IN-CAR CHARGER
KFZ-LADESTECKER
CHARGEUR ALLUME-CIGARE TLS 2 A1
Instruction Manual

IN-CAR CHARGER
Operating instructions and safety instructions

Introduction

Congratulations on the purchase of your new appliance. You have clearly decided in favour of a quality product. These operating instructions are a part of this product.
They contain important information in regard to safety, use and disposal. Before using the product, familiarise yourself with all of these operating and safety instructions. Keep these operating instructions as a reference and store them near the product. In addition, pass these documents on, together with the product, to any future owner.

Intended use

The car charger adapter is a car accessory that is compatible with the vehicle socket. It is designed solely for charging mobile phones and 5 V devices with a USB port. The car charger adapter is suitable only for vehicles in which the negative terminal of the battery is connected to the bodywork.
Any other use or usage beyond those mentioned is considered improper use and can result in damages and injuries. Claims of any kind for damages resulting from improper use or unauthorised modifications will not be considered. This product is intended for private use only and not for commercial applications.

Notes on trademarks

• USB® is a registered trademark of USB Implementers Forum, Inc.
• iPhone® and iPod® are trade names of Apple Inc., registered in the USA and other countries.
  All other names and products may be trademarks or registered trademarks of their respective owners.

Warnings and symbols used

The following warnings are used in these operating instructions, on the packaging and on the appliance (where applicable):
**DANGER
A warning at this hazard level indicates a hazardous situation.
Failure to avoid this hazardous situation will result in serious injuries or death.
► Follow the instructions on this warning label to avoid the risk of death or serious injuries.
****WARNING
A warning at this hazard level indicates a potentially hazardous situation.
Failure to avoid this hazardous situation could result in serious injuries or death.
► Follow the instructions on this warning label to avoid the risk of death or serious injuries.
****CAUTION
A warning at this hazard level indicates a potentially hazardous situation.
Failure to avoid this hazardous situation could result in injuries.
► Follow the instructions on this warning label to prevent injuries.
ATTENTION
A warning at this hazard level indicates a risk of property damage.
Failure to avoid this situation could result in property damage.
► Follow the instructions in this warning notice to prevent property damage.
NOTE**
► A note provides additional information which will assist you in using the appliance.
The E marking is a test mark for the labelling of components requiring approval in motor vehicles and states that the necessary tests have been carried out and that an ECE component approval has been issued. The letters “xx” are placeholders and stand for the country where the licence was issued.
The Smart Fast Charge symbol indicates that the technology used enables reduced charging time for compatible devices. Compatible connected devices automatically receive a signal to draw the maximum available charging current.

Safety instructions

• Before use check the device for visible external damage. Do not put into operation a device that is damaged or has been dropped.
• Damaged cables or connections should be replaced by authorised qualified specialists or by the customer service department.
• Protect the device from moisture and liquid penetration.
• Never subject the device to extreme heat or humidity. This applies especially when storing in a car. With long periods of immobilization car interiors and glove boxes build up extreme heat levels. Remove electrical and electronic devices from the car.
• This device is not intended for use by persons (including children) with restricted physical, sensory or mental abilities or lack of experience and / or knowledge unless, of course, they are supervised by a person responsible for their safety or obtain from that person instructions on how the device is to be used. Children should be supervised to make sure that they do not play with the device.
• DANGER! Do not allow children to play with the packaging material! Keep all packaging materials away from children. Risk of suffocation!
• DANGER! Some of the supplied parts can be swallowed. If a part is swallowed, seek medical advice as soon as possible.
• Do not operate the appliance if you are driving a car or other vehicle. This presents a source of danger in road traffic.
• When using the car charger, ensure that it does not interfere with the steering, braking or the operation of other vehicle systems (such as airbags) and does not restrict your field of view when driving.
• **WARNING!** Do not place the car charger or the connection cable in or near the expansion area of the airbag, since the charger could be flung through the vehicle interior in the event of airbag deployment and cause serious injuries.
• If you notice a burning smell or smoke coming from the device, disconnect it from the power supply immediately.
• Never open the housing. Opening the housing will invalidate the warranty.

Technical Data

*The maximum output current is 2.4 A when using one USB connection.

Items supplied

Before initial operation check the package contents to make sure everything is there and for possible visible damages. If the package contents are incomplete or are damaged as a result of defective packaging or during transportation get in touch with the Service Hotline (see section “Service”).  Remove all packaging materials from the device.;
The following components are included in delivery

• Car/USB charging adapter
• Connection cable
• 1 adapter mini-USB
• 1 USB type-C adapter
• These operating instructions

Operation

Unpack the charging device and all adapters and look for the adapter suitable for your mobile phone.
To charge an iPhone / iPod, use the original cable with the USB port. First check to make sure that the adapter fits.
NOTE
► Do not apply excessive force thus avoiding damage to the connector. This also applies when removing the connector.

• Now plug the charging device into the 12/24 V power socket of your car. As a rule this is the cigarette lighter socket in the dashboard of your car. Numerous vehicles have  a second socket in the rear seat area or in the boot. 24 Volt batteries are used, primarily, in trucks or on boats.
• The white LED indicates that the charger is ready for use. It also lights up when no mobile phone is connected. Depending on the vehicle type it is possible that the ignition has to be switched on first. The charging process begins immediately and is shown in your mobile phone’s display.
• When charging is complete, disconnect the charger from the 12/24 V connection.

ATTENTION
► Never connect the device without charging your mobile phone! The device also consumes power in standby mode and therefore must be disconnected from the
on-board power supply after use! If the motor is not running the battery will otherwise be discharged.

Troubleshooting

A connected device will not charge (the white LED does not light up)

• No connection to the car’s cigarette lighter socket. Check the connection.
• Depending on the vehicle type, it is possible that the ignition has to be switched on first.

The white LED goes out when a device is connected

• The charger is overloaded and will no longer charge attached devices. The internal overcurrent protection has been triggered. Disconnect all connected devices
  from the charger. The white LED lights up immediately and the charger is ready for use.

NOTE
If you cannot solve the problem with the abovementioned solutions, please contact the Service Hotline (see section “Service”).

Cleaning and storage

ATTENTION
► Always disconnect the device from the 12/24 V connection when cleaning and when it is not being used.
► Temperatures inside the vehicle can reach extreme levels in summer and winter. Therefore, to avoid damage to the device, do not store it in the vehicle.
► Do not use caustic, abrasive or solvent-based cleaning materials. These can damage the surfaces of the device.

• When necessary clean the device with a soft cloth.
• Store the device somewhere clean, dry, free of dust and out of direct sunlight.

Disposal

The adjacent symbol of a crossed-out wheelie bin means that this device is subject to Directive 2012/19/EU. This directive states that this device may not be disposed of in normal household waste at the end of its useful life, but must be brought to a specially set-up collection point, recycling depot or disposal company.
This disposal is free of charge for the user. Protect the environment and dispose of this device properly.
To find out about options for disposal of the used product, please contact your municipal or city administration.
** The packaging materials have been selected for their environmental friendliness and ease of disposal and are therefore recyclable. Dispose of packaging materials that are no longer needed in accordance with applicable local regulations.
Dispose of the packaging in an environmentally friendly manner. Note the labelling on the packaging and separate the packaging material components for disposal if necessary. The packaging material is labelled with abbreviations (a) and numbers (b) with the following meanings:
1–7: plastics,
20–22: paper and cardboard,
80–98: composites.
Applies only to France:**

The product, its packaging and the operating instructions are recyclable. They are subject to an extended manufacturer responsibility and will be collected separately.

Kompernass Handels GmbH warranty

Dear Customer,
This appliance has a 3-year warranty valid from the date of purchase. If this product has any faults, you, the buyer, have certain statutory rights. Your statutory rights are not restricted in any way by the warranty described below.
Warranty conditions
The warranty period starts on the date of purchase. Please keep your receipt in a safe place. This will be required as proof of purchase.
If any material or manufacturing fault occurs within three years of the date of purchase of the product, we will either repair or replace the product for you or refund the purchase price (at our discretion). This warranty service requires that you present the defective appliance and the proof of purchase (receipt) within the three-year warranty period, along with a brief written description of the fault and of when it occurred.
If the defect is covered by the warranty, your product will either be repaired or replaced by us. The repair or replacement of a product does not signify the beginning of a new warranty period.
Warranty period and statutory claims for defects
The warranty period is not prolonged by repairs effected under the warranty. This also applies to replaced and repaired components. Any damage and defects present at the time of purchase must be reported immediately after unpacking. Repairs carried out after expiry of the warranty period shall be subject to a fee.
Scope of the warranty
This appliance has been manufactured in accordance with strict quality guidelines and inspected meticulously prior to delivery.
The warranty covers material faults or production faults. The warranty does not extend to product parts subject to normal wear and tear or to fragile parts which could be considered as consumable parts such as switches, batteries or parts made of glass.
The warranty does not apply if the product has been damaged, improperly used or improperly maintained. The directions in the operating instructions for the product regarding proper use of the product are to be strictly followed. Uses and actions that are discouraged in the operating instructions or which are warned against must be avoided.
This product is intended solely for private use and not for commercial purposes. The warranty shall be deemed void in cases of misuse or improper han- dling, use of force and modifications / repairs which have not been carried out by one of our authorised Service centres.
Warranty claim procedure
To ensure quick processing of your case, please observe the following instructions:

• Please have the till receipt and the item number (IAN) 408717_2207 available as proof of purchase.
• You will find the item number on the type plate on the product, an engraving on the product, on the front page of the operating instructions (below left) or on the sticker on the rear or bottom of the product.
• If functional or other defects occur, please contact the service department listed either by telephone or by e-mail.
• You can return a defective product to us free of charge to the service address that will be provided to you. Ensure that you enclose the proof of purchase (till receipt) and information about what the defect is and when it occurred.

PDF ONLINE
www.lidi-service.com

You can download these instructions along with many other manuals, product videos and installation software at www.lidl-service.com.
This QR code will take you directly to the Lidl service page (www.lidl- service.com) where you can open your operating instructions by entering the item number (IAN) 408717_2207.
Service
Service Great Britain
Tel.: 0800 404 7657
E-Mail: kompernass@lidl.co.uk
Service Ireland
Tel.: 1800 101010
E-Mail: kompernass@lidl.ie
IAN 408717_2207
Importer
Please note that the following address is not the service address. Please use the service address provided in the operating instructions.
KOMPERNASS HANDELS GMBH
BURGSTRASSE 21
44867 BOCHUM
GERMANY
www.kompernass.com

References

• ce.com
• Kompernaß - Online shop for accessories and spare parts
• de/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>