Combustion Inc 1003 Charger Repeater User Guide

Getting started with your Combustion Booster

1.  Charge your Booster 20 min.
   • Use the included USB cable and any USB power supply (a phone charger works great)
   • The light will blink amber as the Booster charges
   • When the Booster is charged, the light will turn green

2. Link your Booster to your Predictive Thermometer
   • Unplug the Booster
   • The light will flash white 3 times in a row to show it’s searching (this sequence repeats)
   • Hold a (fully charged) Predictive Thermometer near the Booster
   • A single green blink indicates the link has been established (it will blink every 2.5 seconds) Congrats, your Booster is now repeating the Thermometer’s Bluetooth signal!

The Booster light—and what it’s trying to tell you:
Modes
Portable Charger
Mode With the Booster unplugged, the onboard battery can recharge your Predictive Thermometer.
The light will blink amber when the thermom-eter is charging.
NOTE: Booster will not act as a repeater while it’s recharging a thermometer.
Wall Charger Mode
With the Booster plugged in, it will recharge itself and the Predictive Thermometer.
If either is charging, the light will blink amber.
When both are charged, the light will turn green.
Power management
When the Booster is not plugged in, it will search for linked MeatNet-enabled Combustion tools (Predictive Thermometer, Display) to connect with.
If no connection is found, it will power itself down in 3 minutes.
To turn it back on, press the button (light). If connected (green blink), the Booster will remain on. To turn it off, hold the button (light) for 1 second.
Firmware update
Follow the instructions in the Combustion App to update the Booster’s firmware (its internal operating system).

Cantion:
‘The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device contains licence-exempt transmitter(s}/receiver(s} that comply with Innovation, Science and Economic Development Canada’ s licence-exempt RSS(s) and Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital  device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates,  uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
POC&IC Radiation Exposure Statement: ‘This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Thermometer Storage

Booster Functions

Max Temperatures

Charging

Designed by Combustion, Inc., in Seattle WA, USA.
All rights reserved. The Combustion Inc. logo is owned by Combustion, LLC.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>