PETLIBRO PLAF001 4L Automatic Pet Feeder User Guide
- June 11, 2024
- PETLIBRO
Table of Contents
PETLIBRO PLAF001 4L Automatic Pet Feeder User Guide
4L Automatic Pet Feeder
User Guide
Model: PLAF001
Please read this User Guide before using the product and retain for reference. This product is intended for household use only.
Safety Precautions
! WARNING
- Dispose of all packaging materials properly. Some items may be packed in polybags; these bags could cause suffocation; keep away from children and pets.
- Do NOT allow small children to play with, in or around the pet feeder.
- To reduce the risk of injury, please keep close supervision when an appliance is used near children.
- Do NOT use the feeder with pets not able to reach the food tray or with any physical disability.
- Do NOT immerse the base part in water at any time as it may damage electronic components like the control panel.
- Do NOT place any foreign object in the pet feeder:
- Do NOT use outdoors. Check operation frequently to be sure the unit is dispensing properly.
- Do NOT use wet, canned or moist food.
- Do NOT disassemble the unit other than as instructed in this User Guide.
- Do NOT use the feeder for anything other than its intended use.
- Only use attachments recommended or sold by the manufacturer. The use of attachments not recommended or sold by the manufacturer may cause an unsafe condition. Do not modify the pet feeder.
- Do not operate any appliance if the unit is malfunctioning or has been damaged. Do not attempt repairs on the pet feeder yourself. Contact our customer service immediately for further instructions.
- Always unplug when not in use and before cleaning.
- Never pull on the electrical power cord to remove the plug from the wall outlet.
- If the plug of this device gets wet, turn off electricity to that wall outlet. Do not attempt to unplug.
- Examine the feeder after installation. Do not plug in if there is water on the power cord or plug.
- To avoid tripping, always position power cord out of the way of foot traffic.
CAUTION
- Do NOT allow pets to chew on or swallow any parts. If you are concerned about the power cord, purchase a cord conduit [a hard plastic protector) at any hardware store to protect the power cord.
- If an extension cord is necessary, one unit with a proper rating should be used.
- Do NOT install or store the pet feeder where it will be exposed to weather or temperatures below 4°C / 39°F.
- Use alkaline D batteries to power. Do NOT use rechargeable batteries.
- Check the batteries regularly. Before leaving for extended time, always replace batteries with new ones.
- Do NOT lift the pet feeder by lid, food tank, or food tray. Lift and carry it using both hands and the base, while keeping the unit in an upright position.
- Suitable for dry food ONLY, with kibble size ranging from 2-10mm / 0.07-0.4in in diameter. Larger kibble may get stuck at the food outlet.
- Read and observe all important notices listed on the pet feeder and in the packaging.
Product Diagram
Front View
Bottom View
- Desiccant Carrier
- Lid
- Lid Grip
- Food Tank Buckle
- Base
- Food Outlet
- Food Tray
- Control Panel
- LCD Display
- Food Tank
- Battery Compartment
- Speaker
- Power Socket
Cleaning & Care
Ifs recommended to clean the feeder regularly for the health of your pet.
The washable parts of the Petlibro auto feeder are as follows: food tank, food tray, and lid (without desiccant bag]; they can be submerged in water. Clean by hand-washing using cool or warm soapy water.
– Dissembling the food tank
If you have food inside the tank or chute, press the Unlocked button and Feed
button for a few times to empty first.
Press the food tank buckles with your thumbs, push the tank upward to disassemble.
– Dissembling the food tray
Empty the tray, press it down to remove from the base.
Rinse and let all parts air dry completely before assembling.
Note : Be careful not to hurt your fingers when disassembling the food
tank by great strength.
Warranty
We provide a 1-year warranty for this appliance. Please email our support team at support@petlibro.com if you have any questions, and attach your order ID in your email. We’ll get back to you as quick as possible.
What’s in the box
1 x Automatic Pet Feeder
1 x 5V Power Adapter
1 x Desiccant Bag
1 x User Guide Kit
How To Use
Warning: Please use the original 5V power supply.
Specifications
Scan for more details
www.petlibro.com
PETLIBRO 4L Automatic Pet Feeder
Model, PLAF001
©Li bro Corp. All Rights Reserved.
Manufacturer: Shenzhen Libra Technology Co., Ltd
Address: Building 3, Cloud Park, Shenzhen, China, 518129
Made in China
PLAF001 4L V1 .2
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received. including interference
that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>