Orbit CAMPFIRE AUDIO Earbuds User Manual
- June 9, 2024
- Orbit
Table of Contents
CAMPFIRE AUDIO Earbuds
Pairing & Quick Reset
FCCID:2AS58-01
FCC Compliance This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment to an outlet on a circuit different from that to which the receiver
is connected. Consult the dealer or an experienced radio/TV technician for
help. Changes or modifications to this product not authorized by Campfire Audio
could void the electromagnetic compatibility (EMC) and wireless compliance and
negate your authority to operate the product. This product has demonstrated
EMC compliance under conditions that included the use of compliant peripheral
devices and shielded cables between system components. It is important that
you use compliant peripheral devices and shielded cables between system
components to reduce the possibility of causing
interference to radios, televisions, and other electronic devices. Responsible
party (contact for FCC matters only): Campfire Audio – Compliance 2400 SE
Ankeny, Portland, Oregon, USA –
Campfireaudio.com/compliance
ISED Canada ICID：
24976-01
This device complies with ISED Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device. CAN ICES-3 (B)/NMB-3(B)
Campfire Audio LLC. hereby declares that this wireless device is in
compliance with Directive 2014/53/EU and Radio Equipment Regulations 2017.
A copy of the Declaration of Conformity is available
atCampfireaudio.com/compliance
Frequency Maximum Power 2.4GHz (Bluetooth®) < 100mW Japan
Singapore Complies with IMDA Standars DA105282
Taiwan Le: CCAJ22LP3090T7
Right: CCAJ22LP30A0T9
South Korea R-R-CFa-2AS58-01 10/22
Australia / New Zealand
Hong Kong
HKOO22200110
Russia, Kazakhstan, Belarus, Armenia, Kyrgyzstan
The symbol beside means that according to local laws and regulations your
product and/or its battery shall be disposed of separately from household
waste. When this product reaches its end of life, take it to a collection
point designated by local authorities. The separate collection and recycling
of your product and/or its battery at the time of disposal will help conserve
natural resources and ensure that it is recycled in a manner that protects
human health and the environment.
© 2022 Campfire Audio LLC. All rights reserved. Campfire Audio, Campfire Audio
Logo, CA logo, Nicely Done, and Orbit are trademarks of Campfire Audio LLC.,
registered in the U.S. and other countries.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Campfire Audio LLC is under
license.
To remove your earphone tips pull the tip in the direction parallel to the
earphone spout.
To place a new tip on the spout, squeeze the tip slightly, catch the inside
edge, and roll it onto the spout. This action may take some practice to
perfect, but the right tip goes a long way in improving the sonic performance
of your earphones.
Take care not to drop your earphones. Each Campfire Audio Orbit earphone holds
a sensitive and finely tuned transducer. Sudden shocks or impact to the shell
can
potentially cause damage or alter the performance of the earphone’s
transducer. Damage to the earphone transducers (drivers) are not covered under
the earphone’s
warranty protection and are subject to a reasonable fee for repair. Take
special care to keep the earphone openings clear of debris and wax and remove
build up from the earphone regularly. Take extra care not to push any foreign
objects into the canal of the earphone openings. Avoid extended exposure to
excessive moisture.
Opening the body of the earphone will damage the seal of the shell and alter
the precision tuning of your earphone. Tampering, opening, or altering the
shell will void the warranty of your earphone.
Note that extended listening periods at high listening levels can negatively
impact your hearing over time. Please enjoy listening to your earphones
responsibly.
Questions or comments? Please contact us: Support@CampfireAudio.com
Specifications
Frequency Response: 5Hz – 20kHz
Earphone Connection: Bluetooth® 5.2
Supported Codecs: SBC, AAC, AptX®
Batteries
Earphones: 50mAh,
8.5 Hours in 80% Volume Playtime in single full charged Case: 270mAh,
30 Hours Total Playtime Reserve
Input: 5V 260mA
Warranty
Orbit includes a 1 year limited liability product warranty covering defects
due to manufacturing and assembly. For more information visit
Campfireaudio.com/warranty
Insert Orbit earphones into your ear with the spout facing forward and logo upright and closer to your face. Earphones are marked ‘L’ for left and ‘R’ for right on the inward facing wall of the earphone body. Use the included tips to find the proper fit and secure seal. Enjoy!
https://campfireaudio.qrd.by/orbit_app
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>