Orbit 28566-50 Outdoor Swing Panel Timer User Guide

Orbit 28566-50 Outdoor Swing Panel Timer

Product Information

Specifications:

• Model: Outdoor Swing Panel Timer
• Part Number: 28566-50 rB
• Battery: One Lithium CR2032 (included)
• Power Source: Electrical power
• Required Tools: Phillips Screwdriver, Wire Strippers

Product Usage Instructions

Selecting the Location:
Choose either an indoor or outdoor location that is clean, dry, and out of direct sunlight. Allow a 9-inch clearance for the swing door.

Mounting the Timer:
Using the provided mounting template, mark screw locations on the wall. Screw through one of the pre-formed mounting holes and hang the timer on the screw using the keyhole.

Connecting Sprinkler Valves to Timer Wires:
Connect the sprinkler valves to the timer wires. Push tab upward to release wire and use wire nuts for secure connections.

Connecting to Electrical Power:
For indoor use, connect the timer to an electrical power source. For outdoor wiring, please refer to the full manual available at www.orbitonline.com.

Activating Battery:
Remove the plastic strip to activate the pre-installed lithium CR2032 battery. This battery is required to retain the program in memory during power loss.

Operating the Timer:
Use the buttons and functions on the swing-out panel accordingly:

• A – ENTER: Confirm a new setting

• B – CLEAR: Clear a setting

• C – PROGRAM: Switch between programs – A, B, and C

• D – ARROW []: Skip to the next setting or move to other
  programs/settings

• E – ARROW []: Go back to the previous setting or move to other programs/settings

• F – RAIN DELAY: Pause operation for 24-72 hours due to rain or other factors

• G – [ +]: Increase a numeric setting

• H – [ – ]: Decrease a numeric setting

Note: The quick start guide is intended to help you get up and running with your new timer. It includes basic installation and programming help. For more detailed and advanced instruction, please download the full manual “Outdoor Swing Panel Timer” at www.orbitonline.com

SELECT LOCATION

For detailed instructions on outdoor wiring, please download the full manual “Outdoor Swing Panel Timer” at www.orbitonline.com

Warning: Check state and local codes. Orbit recommends using a licensed electrical contractor for outdoor wiring of timer.

MOUNT TIMER

CONNECT SPRINKLER VALVES TO TIMER WIRES

Connect one of the two wires from each valve to the common wire leading to the timer (usually white). Connect the other wire from each valve to one of the colored wires leading to the timer.

CONNECT VALVE WIRE TO TERMINAL

Do not connect to power source until after wiring valves to timer

CONNECT TO ELECTRICAL POWER

Warning: See manual for outdoor wiring instructions

ACTIVATE BATTERY

BATTERY WARNING: Chemical Burn Hazard. Keep batteries away from children. This product contains a lithium coin cell battery. If a new or used button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as two hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battery, and keep it away from children. If you think the battery might have been swallowed or placed inside any part of the body, seek immediate medical attention. The battery should be disposed of properly and kept away from children. Even used batteries may cause injury.

Button Function:

1. ENTER – To confirm a new setting
2. MANUAL – To water manually
3. CLEAR – To clear a setting
4. PROGRAM – to switch between programs – A, B, and C
5. ARROW – To skip to the next setting / watering station or move to other programs/settings
6. ARROW – To go back to the previous setting / watering station or move to other programs/settings
7. RAIN DELAY – To pause operation for 24-72 hours due to rain or other factors
8. [+] – To increase a numeric setting
9. [ -] – To decrease a numeric setting
10. AUTO – Watering mode
11. SET CLOCK – Set calendar and clock time
12. SET DATE – Year, Month, and Day
13. START TIME – Set time to begin watering
14. RUN TIME – Set watering duration for each station
15. HOW OFTEN – Set frequency of watering days
16. BUDGET – Adjust overall watering as a percentage
17. OFF – Turn all stations off

PROGRAM TIMER

1. Set Current Time (e.g. pacific, mountain standard)

2. Set Date

   • Turn dial to SET DATE to enter the Year, Month and Day.
   • Use the (+/-) button to select the Year.
   • Press [ENTER] to advance to Month and Day.

3. Set Start Time Time to begin watering

   • Turn dial to START TIME position.
   • Enter one start time using the (+/-) button.
   • Press the [ENTER] button to save.
     Note: Additional start times – Additional start times can be entered if you want your sprinklers to water the same area multiple times a day. For instructions please download the “Outdoor Swing Panel Timer” manual at www.orbitonline.com.

4. Select Watering Duration Set for each station then press enter Turn dial to run time enter the watering duration (+/- ) for each station ([ENTER] or [ARROW] to move between stations).

5. **Set Watering Days or Interval

** Turn dial to how often to select watering days ([ARROWS] to move and [ENTER] to select). To water on Odd or Even days or to water using Intervals days, please download the full manual “Outdoor Swing Panel Timer” (at www.orbitonline.com) for instructions.

6. Set Auto Mode

ADDITIONAL FEATURES

RAIN DELAY

• Turn dial to AUTO and Press the [RAIN DELAY] button.
• Push the [+/-] to select 24, 48 or 72 hours.
• Press [ENTER] to begin.
• Press [CLEAR] to cancel the rain delay.

MANUAL WATERING
Your timer has the ability to allow you to manually water without disturbing the preset program.

To Run all stations at the pre-programmed duration

• Turn the dial to AUTO.
• Press the [MANUAL] button. Display will show A B and ALL.
• Press [ENTER] (or wait a few seconds) to begin manual watering.

All stations will water consecutively for their programmed duration.

To Run a specific station for a specified time

• Turn the dial to AUTO.
• Press the [MANUAL] button.
• Press the  ****/ buttons until the desired station number appears.
• Press the [+/–] to enter the desired duration.
• Press [ENTER] (or wait a few seconds) to begin manual watering.

To stop Manual Watering press [CLEAR].

Note: After the [MANUAL] button has been pushed, if a selection is not made within 5 seconds all stations and programs will beginwatering using the programmed RUN TIMES. If no RUN TIMES have been set, nothing will happen and the display will return to the time of day.

BACKUP BATTERY

Your timer requires a CR2032 Lithium battery to maintain your program in case of an AC power loss.

Tip: The Battery should be replaced every year, to avoid loss of programming.

BATTERY WARNING:

• Chemical Burn Hazard. Keep batteries away from children.
• This product contains a lithium coin cell battery. If a new or used button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as two hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battery, and keep it away from children.
• If you think the battery might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• The battery should be disposed of properly and kept away from children. Even used batteries may cause injury.

Note: A battery alone will not operate the valves in your sprinkling system. The sprinkler timer transformer must be connected to an AC line voltage source.

For instructions on “Water Budgeting”, connecting the timer to a “Pump Start” relay, replacing the “Backup Battery” or for installing your timer outdoors, please download the full manual “Outdoor Swing Panel Timer” at www.orbitonline.com

DOWNLOAD THE ORBIT B-HYVE LITE APP

• Let the Orbit B-hyve Lite app take the guess work out of programming your sprinkler timer.
• Download the “Orbit B-hyve Lite” app.
• After download, the app will guide you through setting up an account and entering information about your landscape.

B-HYVE LITE APP FEATURES

• Weather Alerts
  Weather alert notifications on your smart device offer suggestions for when to activate the rain delay feature or adjust programming.

• Programming Recommendations
  Using historical local weather data and information about your landscape, the B-hyve Lite app will make monthly programming recommendations customized to your yard.

• Water Audit
  Conduct your own watering audit—in app watering app tool allows for up to 50% savings on water use—catch cup watering tool.

• Save Water and Money
  Based on historical weather data for your zip code, you will receive recommendations on how to program your timer for optimal watering throughout the season, saving water and money.

• Zone Identity
  Name and photograph each of your watering zones making it easy to identify each of your water areas.

*Upgrade easily to the B-hyve WiFi Sprinkler Timer and make smart watering automatic while giving you control of your sprinkler timer from anywhere in the world. The Orbit WiFi timer communicates to the B-hyve cloud and automatically adjusts your sprinkler programming throughout the watering season. B-hyve WiFi timers are EPA WaterSense certified and may be eligible for rebates in your area. The easy-set-logic timer is not wifi enabled. The B-hyve Lite app offers programming set-up and adjustments you can manually enter to potentially improve your watering performance.

HELP
1-800-488-6156 or 1-801-299-5555 www.orbitonline.com
Before returning this sprinkler timer to the store, contact Orbit Technical Service at 1-800-488-6156, or 1-801-299-5555.

LISTINGS

• The sprinkler timer is tested to UL60730 standard & is ETL listed.
• Appropriate international models are CSA and CE approved.

This Class B digital apparatus complies with Canadian ICES-003.

• Disconnection: Type 1Y
• Input: 120V, 60Hz, 0.2A; Output: 26V, 5OOmA
• Rated impulse voltage: 2500V
• Pollution degree: 2 The supply cord of this control can be replaced only by the manufacturer or his accredited service agent.

NOTICE
The information in this manual is primarily intended for the user who will establish a watering schedule and enter that schedule into the sprinkler timer. This product is intended to be used as an automatic sprinkler timer for activating 24 VAC irrigation valves, as described in this manual.

WARRANTY AND STATEMENT

Orbit Irrigation Products, Inc. warrants to its customers that its products will be free from defects in materials and workmanship for a period of six years from the date of purchase.
We will replace, free of charge, the defective part or parts found to be defective under normal use and service for a period of up to six years after purchase (proof of purchase required).
We reserve the right to inspect the defective part prior to replacement.
Orbit Irrigation Products, Inc. will not be responsible for consequential or incidental cost or damage caused by the product failure. Orbit® liability under this warranty is limited solely to the replacement or repair of defective parts.
To exercise your warranty, return the unit to your dealer with a copy of the sales receipt.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.

FAQ

Q: Can I use multiple valves with this timer?
A: Yes, you can connect multiple sprinkler valves to the timer by following the wiring instructions provided in the manual.

Q: How often should I replace the battery?
A: It is recommended to replace the lithium CR2032 battery annually to ensure proper functioning and retention of programming during power loss.

References

• Smart Watering, Sprinkler & Drip Systems – OrbitOnline
• Smart Watering, Sprinkler & Drip Systems – OrbitOnline

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>