POWERQI LC50 3 In 1 Wireless Charging Station User Manual

: June 9, 2024
: POWERQI

Table of Contents

LC50 3 In 1 Wireless Charging Station
Specification
Charging Mode
FCC Warning
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LC50 3 In 1 Wireless Charging Station
User Manual

LC50 3 In 1 Wireless Charging Station

Product Colour, Material & Finishing Specifications

Thanks for choosing us!
“This productids a 3in 1 wireless charger, support phone/AirPods/ Apple Watch charging at the same time.
Please kindly read the user manual before using and keep it or future efference,

Specification

Input: DCSV,3A DCSY3A
Output{Phone): SW/T.5W
Output(Apple Watch: 3w
Output{AirPods): SW
Frequency:
115-205KHz(for Phone & AirPods US)
110205 Kisoro Phone & Airpods,for EU)
325KHzlfor Apple Watch)
Charging distance: <10mm
Conversion: 72%
NW: 205g
Dimensions: 80107 130mm

Charging Mode

Make sure the ireless charger deck connect o the power supply.
Put the smartphone/AirPods/Apple Watch properly on the transmitter.

Notes

Do not squeeze or collisions.
Do not disassemble or throw into fire or water, to avoid causing a short circuit leakage.
Do not use wireless charger in severely hot, humid or corrosive environments, to avoid circuit damage and occurs leakage phenomenon.
Do not place too close with magnetic stripe or chip card ( ID card, bank cards, etc. ) to avoid magnetic failure.
Please keep the distance at least 20cm between implantable medical devices ( pacemakers, implantable cochlear, etc. ) and the wireless charger, to avoid potential interference with the medical device.
To take care of the children, to ensure that they won’ t play the wireless charger as a toy, to avoid unnecessary accidents.

The involved images are sketch maps, the final product as per the material subjects.
Includes: wireless charger, Power cable , user’ s manual.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body