ESL VISION 6-ft Cord Set for LED Vapor Tight Light Installation Guide
- June 9, 2024
- ESL VISION
Table of Contents
6-ft Cord Set for LED Vapor Tight Light
VAPOR TIGHT SERIES
Product Installation Guide
6-ft Cord Set for LED Vapor Tight Light
WARNING
- To avoid the risk of fire or electric shock, disconnect power at the source prior to installation.
- The installation should be performed by qualified electricians or lighting technicians.
- To prevent damage, do not expose wiring to sheet metal edges or other sharp objects.
- Do not make holes or alter the enclosure or components during kit installation.
- If there is any problem with the fixture, turn off the power and DO NOT attempt repair unless you are a qualified technician or the customer service member.
Surface Mount Installation
- Drill holes in the mounting surface, and use the included hardware to mount the brackets.
- Fix the mounting clips to the housing recesses by firmly pressing them into place until both sides of the clip are secured.
- Release the latches by pulling the top away from the housing.
- Without touching the LED boards, detach the LED tray and lens from the fixture.
- Make sure the power supply is disconnected, and connect the power driver as shown in the General Wiring Diagram. (Below)
- Select the desired wattage and kelvin with the switches located on the driver. Reattach the LED Tray to the fixture.
- Secure lens to housing by locking the latches.
Chain Suspended Installation
- Attach a V-Bracket to each mounting clip by spreading the ends apart and inserting the legs into the holes on each side.
- Secure the mounting clips to the housing recesses by firmly pressing them into place until both sides are secure.
- Hang the fixture from the chain kit (sold separately).
- Release the latches by pulling the top away from the housing.
- Without touching the LED boards, detach the LED tray and lens from the fixture.
- Make sure the power supply is disconnected, and connect the power driver as shown in the General Wiring Diagram. (Below)
- Select the desired wattage and kelvin with the switches located on the driver. Reattach the LED Tray to the fixture.
- Secure lens to housing by locking the latches.
General Wiring Diagram
Field Selectable Wattage & CCT
Select desired color temperature and wattage output combination with the
switches located on the side of the driver.
Copyright © 2022 ESL Vision, LLC. All rights reserved. Rev: 11/30/22
888.493.5559
info@eslvision.com
www.eslvision.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>