ESL VISION ESL-EMG-SL5-CLW-5W Emergency Driver Instruction Manual
- June 9, 2024
- ESL VISION
Table of Contents
ESL VISION ESL-EMG-SL5-CLW-5W Emergency Driver
INSTALLATION INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS PRODUCT INCLUDES THE FOLLOWING COMPONENTS
PARTS QUANTITY
- LED Emergency Driver 1
- Instruction Sheet 1
- Wire Nut 2
- Test Button 1
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- WARNING : Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for installation of LED Emergency Backup. Check for enclosed wiring and components.
- WARNING : Risk of fire or electric shock. This LED Emergency Backup installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- WARNING : Risk of fire or electric shock LED Emergency Backup is only for use in surface mount or recessed Type IC or Non-IC luminaires listed to UL Standards. Suitable for use in damp locations and plenum spaces. Not for use in heated air outlets or hazardous locations.
- WARNING : Risk of fire or electric shock. Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
- WARNING : To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- WARNING : Do not make or alter any open holes of the wiring enclosure or electrical component enclosure during installation. Only those open holes indicated in the instructions and/or drawings may be added or altered as a result of LED Emergency Backup installation. Do not leave any other open holes in the wiring enclosure or electrical component enclosure during installation.
- CAUTION : Before installing, make certain the AC power to the fixture is off.
- CAUTION : The electrical rating of this product is 120-277V. Installer must confirm that there is 120- 277V at the fixture before installation.
- CAUTION : To prevent electrical shock, only mate unit connector after installation is complete and before the AC power to the fixture is back on.
- CAUTION : This fixture provides more than one power supply output source. To prevent electrical shock, disconnect both normal and emergency sources by turning off the AC branch circuit and disconnecting the unit connector.
- CAUTION : This is a sealed unit. Components are not replaceable. Replace the entire LED Emergency Backup unit when necessary. Do not use outdoors.
This LED Emergency Backup unit requires an un-switched AC power source of 120-277V, 50/60 Hz. The AC driver MUST be on the same branch circuit as the LED Emergency Backup unit. Do not let power supply cords touch hot surfaces. Do not mount near gas or electric heaters. Install in accordance with the National Electrical Code and local regulations. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Do not use this equipment for other than intended use. The Driver is intended for ordinary locations and for permanent installation into one or more Listed emergency luminaires. Copyright© 2021 ESL Vision, LLC. All rights reserved. Rev: 07/20/2021
- 888.493.5559114
- info@eslvision.com
- www.eslvision.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>