ESL VISION 840 Series Troffer Retrofit Installation Guide
- June 3, 2024
- ESL VISION
Table of Contents
840 SERIES
Troffer Retrofit
Installation Guide
840 Series Troffer Retrofit
WARNING
- To avoid electric shock, disconnect power at source prior to installation.
- The installation should be performed by qualified electricians or lighting technicians.
- Before conducting any installation, maintenance, or removal, disable all power.
- Do not touch the fixture while it is in service.
- If there is any problem with the fixture, turn off power and DO NOT attempt repair unless you are a qualified technician or the customer service member.
Retrofit Installation
Notice:
The existing fluorescent housing must be larger than those in the table below:
| HOUSING DESIGNATION | OVERALL INNER DIMENSIONS |
|---|---|
| 2′ X 2′ | 24.02″ (L) x 23.94″ (W) x 3.07″ (H) |
| 2’ X 4’ | 48.03″ (L) x 23.94” (W) x 3.07” (H) |
| 1’ X 4’ | 48.03” (L) x 12.00″ (W) x 3.94″ (H) |
| 1 |
existing hardware, leaving the supply and ground leads.
---|---|---
2| | Install LED panel end brackets to each end of the existing fixture by
gently lifting it and placing LED panel end brackets between the fixture and
T-grid. If needed, to reduce space between the fixture and T-grid, install
side brackets in the gap. There are two tabs that allow placement of the side
brackets into the slot of the end brackets.
3| 
| Secure the LED panel brackets to the existing fixture using the
provided #8×1/2″ self-drilling screws.
4| | Locate the door assembly body, and place onto the keyholes of the end
brackets.
5| | Slide the door assembly body horizontally to the end of the slots.
6| 
| Hook the safety cables into the holes positioned in the end
brackets.
7| | Use the provided wire caps to connect the wire leads of the troffer kit
to the main power leads as shown in Wire Diagram 1.
8| 
| Secure the door assembly body by locking the latches riveted to
each end of the door frame.
Wiring Diagram 1
Wiring Diagram 2
Field Adjustable Wattage and CCT
- Kelvin and wattage can be adjusted using the dip switches located on the driver.
- Select the desired kelvin and wattage by sliding the dip switch.
Copyright © 2022 ESL Vision, LLC. All rights reserved. Rev: 07/19/22
888.493.5559
info@eslvision.com
www.eslvision.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>